20 Most Recent Fisher and Paykel GWL11 Top Load Washer - Page 2 Questions & Answers

first thing to look at is the sensor either faulty or corroded connection block if good or a new one doesnt fix it then most likely the main computerboard fault

no not thst i know of but its always been a problem with them over tha last 20 years

its really important the R.P.S you replaced is correctly fitted so double check it,also the connecting block if corroded in anyway will cause the faulty its easy to see the bluey color of corrosion, i have struck faulty new sensors beforebut not all thst common if you are really sure all that is 100% then it can only be the wiring loom

with power to machine but all lights off press temp water down button and power button at the same time machine will give two short beeps release then pree spin speed up button three times the lights that are now on is you fault code

replace the cold water solenoid

one of two things shorted out drain pump,or main board is blown, try pump first

the switch is faulty replace the switch

this is a faulty out of balance switch which is located under the main computer module once replace sgould be ll good

if its the first light and second to last light then its a faulty rotary position sensor

does it flood if left running ? if so replace the cold water solenoid

check for dead pump if good the main computer board

Replace the water inlet valve. That will fix the problem. No need to replace anything else.

The control called a simmerstat is faulty and not regulating. New simmerstat will fix the problem.

usually they need to be sized, hold temp button down and press the on button at the same time machine will give 4 short beeps release, depending on machine size you have press temp up for 5.5kg water leel up for 6.5kg or spin speed up for 7.5kg turn off and on again the power button and your ready to go

Yes pump sounds like it is going bad.

sounds like a faulty rotory postion sensor which is located on the stator which is under the bid white cover at the bottom of the machine

sounds like you have two problems, the burning smell is probably the pump,out of balance is usually due to worn aout suspension rods

if running in short intervals pump can be overheating and protection safety switch isturning off the pump until it cools,replace pump

Sounds like you have a pump issue, make sure it is not blocked or restricted :)