20 Most Recent Maytag Neptune MAH6700A Front Load Washer - Page 6 Questions & Answers

Are you sure this is not an nd and not an np flash code? If so then the code stands for no drain, likely something is clogging the washer pump inlet.

Make sure that the door switch is closing properly. If not, and it is stuck in the "open" position, the unit will not operate. Try bypassing the switch to see if it then runs.

here is all kinds of dimensions http://www.maytag.com/digitalassets/MAH5500BWW/Dimension%20Guide_EN.pdf

Probably not. dryer no heat, first check the thermal fuse, then the ignitor. If the heating is intermittent, check the gas solenoid coils. In any case, be sure the entire exhaust duct is clean

Model number? Gas or electric?

The cabinet make of racked while you were working on it. Loosen the screws and gentle press it to the side that is off and re tighten the screws.

This is what it means: Machine control is attempting to drive the motor but is not seeing any tach response. Visual check shows motor is not moving. (Locked, Hall Sensor fault). If you need additional help let me know

Press "end of cycle" to get machine to normal. Then plug off the wall. Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too. Rate me pl.....if helped.

Check that the water input is wide open (security tap)

Common problems link. If you put in your model# there you will get more detailed results. Maytag Washer Leaking Water

This is probably due to excess detergent blocking the feed into the machine, try removing the tray and washing it in the sink. If this works I would rinse it out every month or so, this could be done in the machine by not putting detergent in the dispenser and putting the machine on a short wash cycle. Hope this helps.

look inside at the locking mechanism, it spring loaded, need to pull backwards to open like you trying to open the door after a cycle or wash. www.ask.com/ www.about.com/ www.wikipedia.org/ www.infolinks.com/ www.searchfiles.org/ www.howto.com/ www.hwto.com/ www.info.com/ www.search.com/ /mfg.name/make/model/how/to/open/locked/door/ /mfg.name/make/model/door/is/open/door/handle/locked/will/not/operate/ you mite call the customer service line for maytag, ask for service tech, tell them what wrong and can they help you resolve this issue. go to there website, look up FAQ section, look for you issues. go on line ask.com your going to have to play with the wording to get the right results you are looking for any of these sites are also very good i alway start with easy site to remember for looking for general information www.ask.com

www.ask.com/mfg.name/make/model#/what-does-the-OD-code-mean/