20 Most Recent Maytag MSD2650H Side by Side Refrigerator - Page 8 Questions & Answers

Contact customer service phone# or google search Hotpoint.

evap fan /circuit ---defrost circuit --electronic panel --or internal compressor damaged from power outage

Any frost build up on inside back freezer wall?

Maybe evaporator fan is freezer is making the noise and needs to be replaced

If you have an MFI2569VEB/2 refrigerator, there is no defrost timer. The defrost function is controlled by an electronic control board located in a compartment on the back of the refrigerator. The tech sheet will be in the top hinge cover for the right door, and will show how to troubleshoot. Be sure to unplug the refrigerator prior to making any checks from the board.

Open the freezer door. Listen for the sound of the motor running. If it isn't, the motor probably needs to be replaced. If you hear the motor, check for frost build-up (blocking access to refrigerator). Remove the frost behind the panel and on the surface, with a hair dryer. Make sure not to overload the freezer baskets or block air access to the motor in the back panel.

Leaking fridge door seals

Is the inlet water valve ok? Does it have a water filter that may be clogged?

Ice maker may be defective or water valve may be defective.

so is it making any ice? and not getting it out of the tray?

here is a link to the parts. providing it is a microwave oven. by looking at the exploded parts list that should give you a good idea how it is taken apart. past the link https://www.appliancepartspros.com/parts-for-maytag-mmv5201ds00.html

don't have a fix for this but here is a video on how they took off a whirlpool ped drawer and this may help jog some thinking on a fix for you. how to put the maytag dryer med3000bw0 base drawer back on it track Yahoo...

It’s a main control board issue and most likely needs replacing after cutting power to it for five minutes to see if board will reset.

I assume water is connected and turned on. If so, you will have to have to select water on display or switch and then hold glass on actuator for until water starts coming out. It may take a couple minutes. Keep filling glass as many times as it takes to get all air from lines.

Sounds like defrost system is working correctly. 10 F isn’t cold enough for a freezer. Make sure condenser fan at compressor is running and also evaporator fan in freezer. Also clean dust off condenser coils. If all that is ok, then you most likely have a sealed system problem.

Most likely display control is bad and needs replacing

you might have a bad start capacitor,try a 3 in 1 compressor relay