20 Most Recent Maytag MGR4452BDW / MGR4452BDQ / MGR4452BDB Gas Kitchen Range - Page 2 Questions & Answers

first thing to check is the ignitor,remove the racks and remove the bottom inside floor,if anything else is there remove it so you can see the ignitor,set the oven to 350,if the ignitor glows but doesn.t ignite the flame in 40 seconds change out the ignitor,the reason why i say this is if the sensor or anything else would bring up an error code.hope this helps.

We provide free diagnostic information when you tell us what brand and model number you are having issues with.
We are available from 7 AM – 7 PM CST. We also provide part removal/installation instructions for our customers when parts are purchased through us.
It is our goal to get you back up and running again ASAP, so please contact us when you need us to help you.
We look forward to hearing you and hope that you have a terrific day. Thank you, Ella
http://www.fixya.com/repair/d499389-accurate_appliance_repair_service

Click the link below :----http://wikisolutions.blogspot.in/2012/02/get-free-answers.html

I repaired it myself. I took it apart and re-enforced the plastic with a strip of metal (where the screws are). It works fine now. Nothing wrong with the circuit board just the poor design. You have to push on the control pad for the oven to function and when the plastic breaks the panel falls in on itself. Plastic with metal screws and NO support behind the panel. A new circuit board costs at least $150 + tax + service call + labor. It probably would be better to buy a new range and all because of the poor design!!!

Hello,
The F1 error code means that the computer thinks a button on the touchpad is stuck. Sometimes this can be resolved by making sure the touchpad connector fits tight into the control board. The F1 code can be cleared by pushing CANCEL/OFF. If it returns the touchpad needs to be replaced GENE

Hi

This means a loose/broken wire on the oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that and the door appears to be closing fine then it is the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.
Daniel