20 Most Recent
Juki DNU-1541 Mechanical Sewing Machine - Page 6 Questions & Answers
Juki HZL-29Z not stitching!
Question edited for clarity, spelling and capitalization.
Question moved from category 'Cars and Trucks', to Juki sewing machine.
When was the machine last serviced? They should be serviced every 2 or 3 years. Most people never service until they fail and then wonder why they failed.
Slow, weak sewing would be caused by the foot pedal having dirty contacts n the insides. It has a wire wound track and a contact terminal.
The fact the needle doesn't go up and down is either caused by it being in bobbin winding mode, or a link has come off inside.
So first thing to do is open up the foot pedal and clean the contacts with electrical switch cleaner (NOT WD40). Then check you aren't in Bobbin winding mode, normally a clutch on the hand wheel.
Or
Take it to Juki Service.
Videos and the Service Manual in the link
https://www.google.com/search?q=Juki+HZL+29+Service
..
Juki e code 808 solulation ddl8700-7
hello
regarding error code E808 mostly happened in SC-920 control:
1- check +33 DC volt output for thread trimmer - bac-ktack- presser foot lifter.
2- check CTL board. ( any electronic components damage )
the most reason for E808 coming from CTL board.
best regards
ASHRAF ABOZID
[email protected]
Cairo - Egypt
Juki MO654DE locks up and will not turn
Remove the needle is possible.
Force it in the normal direction of travel with the handwheel. You can't break it. This tip from a dry cleaners that does repairs and has 6 machines.
Then run the machine full speed with no needle for about 20 seconds.
I removed your duplicate post. When you submit a question, you have to press Refresh to see it.
Why lots of oil leakage?
There might be a mechanical problem with your sewing machine to oil to be leaking and it needs to be repaired and the part that stops the oil from spilling out needs to have something sealing it then too to stop oil from leaking out.
Not finding what you are looking for?