20 Most Recent
Janome Memory Craft 4000 Sewing Machine - Page 2 Questions & Answers
How do i use large spool on janome memory craft 4000
It sounds like the holder is placed too far away from your machine therefore putting too much strain on it and therefore tipping it over. If this dosn;t work you can actually get a holder that attaches to the top of the sewing machine and hangs on the carry handle.
Where is bulb located on lMemory Craft 4000 Janome
I think the 4000 is made similar to my 3000? I just open the left end of the case since it's on hinges and it's a tiny thing in a black housing. the exposed end of the bulb isn't more than 1/4" long.
How do I adjust bobbin tension?
Normally the bobbin is not the part that is tensioned. there is a tension device on the top of your machine for tensioning the needle thread.
How do I adjust bobbin tension?
As far as I know the bobbin is not tensiopned, The needle thread is tensioned, and that is done by routing the thread through the tension device on the top of most machines.
How do I fix the speed of stitching? When I press on the foot feed I get almost no speed from it.
unless it has been progressively getting slower, I did have a simular issue. My pedal was getting "stuck" at the 1/2 mark. (wasn't pressing all the way down). Drove me nuts. Took the machine apart, cleaned oiled, cleaned again blah blah blah...when the pedal was the last option took it apart and found a nut from a screw had gotten inside the pedal and stopping it from pressed down. There could be a burr, a nick or something it is catching on.
Step motor error
The stepper motor or motors control the needle position. If one is reporting an error that just unplugging the machine and leaving it off for 15 minutes won't fix, it's time for a repair shop.
Lcd unreadable
you'll have to contact a Janome dealer that has a repair tech and ask them if they can get one for your machine. and ask them if you can install it yourself.
Not finding what you are looking for?