Top 20
Zebra Z4Mplus Label Printer - Page 8 Questions & Answers
Unable to print a 4X 6 label
asslam aleekum wr wb
mere pass zebra printer hina but us mian ak problem ya arha hian k us k print out blank arhha hian why?
plz mujhe batey
How to set-up the sensor for a special type of media
If the backing has black lines between labels, I would use the mark sensor. If the labels are not genuine Zebra, you will need to pay with the sensitivity of the sensor. To do this, you will need to http on to the printer and you will find the calibration options there. If it asks you for a password, this is 1234.
Print problem
You should make sure you have the label program set for the same size label you are printing and calibrate the printer before you start a roll.
Unable to align printer to
Put in a new roll of labels. Calibrate the printer. Make sure the program you are using is set for the size label you are using. If it calibrates properly, you should end up with the tear off perforation at the edge of the feed out area.
Can't save the printer darkness in the printer
go to printer driver properties..
1.click printing preferences set it to USE PRINTER CONFIGURATION
2.go to advance click Printing Defaults set it to USE PRINTER CONFIGURATION
you must set this two configuration
note: fresh installed driver defaulth to software control
I have a Z4mplus tag
The printer is a monochrome and would need to pass through each color of ribbon.
Not finding what you are looking for?