20 Most Recent Ricoh Aficio CL7200 Laser Printer - Page 8 Questions & Answers

Try checking on the two ends of the rod that supports the transfer belt,you will see the gears that rotate the belt and this gears are held into position by hooked washers it is most likely they are broken and are not hooking to the high tension spring that holds them in position,replace them and reset in the usual manner by going to the maintainance menu on the control panel of the copier.

Morning! When you go to your devices and printers , right click on the ricoh printer and click on printer properties , the go to the advanced tab on top and click on it , then bottom left there should be a option for printing defaults , click on it and select the double sided option there !

Most of the machines you need to press CLEAR ( Yellow Button ), then 107 and hold in stop key for a couple of seconds Hope you get it sorted

if u can't print via usb print by using an ethernet cable and putting a static ip to the machine and install the correct driver get the driver at http://support.ricoh.com/bb/html/dr_ut_e/re/model/mp16/mp16da.htm please select proper driver of the operating system and if it helps let me know or if u don't understand something thanks

Your PCU (fotoconductor Unit) and development needed to be chanded.

May be the key of power saving notwork .you can use dry spray and press this key for 5 or 6 times .

you need to check does the sensor on the drawer which is on the right side front of the drawer, does correspond with the paper inside the drawers.

if you can clean the black line with a cloth, than you need just to replace the cleaning blade, but if the black line is not removing without a cloth, then you need to replace the opc drum and the cleaning blade or both blades, some machines of this type have only one cleaning blade but some have two cleaning blade.

If you go into "user tools" is there a printer and scanner option there? If not the MFD does not have the print option.... If it does you need to program the IP address sub net and gateway. -Carl

If you have used various computers with different OS's and you still cannot get any to recognize the printer, then it would appear that the printer electronics are fubar. U might check with Ricoh but ......................

we have 2 machines that dont work please advice contacts oman

Bad Magenta Development unit