20 Most Recent Ricoh Aficio BP20 Laser Printer - Page 8 Questions & Answers

if you have a MFP try to disconnect HDD

Problem with exposure, Exposure lamp error - White plate, glass, DF belt, mirrors or lens are dirty

SD card authentication error

A correct license is not found in the SD card.

? SD-card data is corrupted.

1. Store correct data in the SD card.

SC-981:Hard drive response error check cables and format hdd. reset error. if error recurs then replace hard drive

Not good, service call required... sorry -Carl

Application start error • Software defective; change the firmware for

the application that failed

• An option required by the application (RAM, DIMM, board) is not installed

This a model information error. The engine firmware not installed correctly. Reinstall firmware.

Main drive jam due to pcu gear fault or main motor is damaged

Maybe TOUCH panel doesn't work. Try to calibrate it: Yellow -->1-->9-->9-->3--> Press Stop(red one) 5 times. 1 - Touch screen adjustment!!! Follow instructions on the screen. After calibrating exit and try again to enter service mode. Good luck Prepare to by new TOUCH Panel Pifonski

https://www.youtube.com/watch?v=xMjvuefnbvA

SC 863-06 means HDD data read failure. Internal HDD of your unit might be faulty cause by a bad sector. On/off the machine might help a bit but sometimes HDD is in very bad condition you need to contact your tech. to check your unit. HDD should be reformat but only tech. can help you to reconfigure it back properly.

The 7,010.43 error code indicates the printer is having difficulty tilting the printhead forward from the parked position to the print position. There are several printer systems involved in tilting the printhead so troubleshooting the error can be challenging. The printer does not directly sense the printhead's tilting position. Instead it applies drive current to the process drive motor, and monitors the motion of the motor's rotation encoder for "following error". For a particular drive voltage the encoder should rotate at a particular rate as the printhead (driven thru the process drive, the DM camshaft, and the head tilt gear train) tilts forward. If the printer does not see the expected encoder readings it assumes a tilt failure. for more hrlp visit CBR Tech Solutions

Last thing you want to do unless you have all the settings information don't recommend doing this

Press user tools/counter then select facsimile then general setting should look for sound and adjusted there will be about 4 different sound settings adjust as needed