20 Most Recent Maytag Neptune MDE5500AY Electric Dryer - Page 2 Questions & Answers


Type Maytag dryer timer problem into YouTube and see if the video comes up, thanks!

Maytag Neptune... | Answered on Dec 03, 2015


It might be the thermal cutoff switch. You could go online to see where it is located for that model dryer and have that tested.

Maytag Neptune... | Answered on Nov 26, 2015


Generally operation when cold that worsens with use indicates a component that is failing when hot. Start at the burner with the coils and work your way back to relays on the control. Sounds a lot like a bad coil on the burner. I have seen these do 2 complete loads then fail. Setting over night and cooling off will work again the same way. Intermittent conditions are a real challenge sometimes.
Eric

Maytag Neptune... | Answered on Nov 12, 2015


Check lint filter. Check blockages in the exhaust hose. Check that the flap outside your wall is not blocked and that the slats or flap opens OK. To get fast drying you have to have a good airflow into the drum and out of it.

Maytag Neptune... | Answered on Oct 22, 2015


a bearing in the back for your drum sounds like what you describe. It needs to be taken apart and the bearing lubricated with high temp grease

Maytag Neptune... | Answered on Aug 21, 2015


If the motor runs, but the drum doesn't rotate, check the belt, part # 341241. It's probably broken and off of the drum.

Maytag Neptune... | Answered on Jun 07, 2015


unscrew all the panels and clean everything with bleach and soap,clean it outside so you can use a hose,soak it down,let it sit without the doors on for a few days in the sun

Maytag Neptune... | Answered on May 12, 2015


Have you had a power surge or power go out when the machine was running-----electronics go coo coo when this happens---it may be resolved by unplugging the dryer for a couple of days---then plug it back in & see if it does it again----another issue if the electronics get wet some how roof leak spilled water/fluid--hose replaced on washer which is usually next to the dryer---also check your owners manual to see if this is an issue do to a malfunction of electronics sending a code to check for an issue--that's all I dream up for now--sorry I couldn't do better

Maytag Neptune... | Answered on Apr 21, 2015


The thermostat may have sensed the heating element getting to hot. Or may have sense electrical fire and tripped the dryer out... I would check the thermostat in the dryer first that is hooked directly to the heating element. Let me know.

Maytag Neptune... | Answered on Apr 20, 2015


unplug it for awhile. Then google " Maytag Neptune MDE5500AY causes for beeping" . Click on appropriate link, and follow what it says

Maytag Neptune... | Answered on Apr 09, 2015


Check your belt.

remove top and front to access

Maytag Neptune... | Answered on Apr 06, 2015


There is not error 18 here is the list:
25120942-xxcgpmvxnqk1u1vs0ulxqbhq-2-0.jpg

Maytag Neptune... | Answered on Mar 15, 2015


The relay for the motor is stuck closed on the control card. Get a new board from local supplier.

Maytag Neptune... | Answered on Mar 08, 2015


Go to Partselect.com. they will ask for model number and serial number of your dryer. They have every single little part for appliances but better yet they have video's on how to make the repairs. They also have schematics for every conceivable appliance made. the prices are very reasonable and the customer service is top notch!

Maytag Neptune... | Answered on Mar 05, 2015


I could be all wet with this but have you check the switch on the door see if it's stuck----also the answers given before are good replies----do you have a schematic?----you've replaced the mother board so depending that's not faulty it should work or you've eliminate one issue---what ever sequence follows the events that start the dryer----by more info--- is the drum turning??----is it turning and your getting no heat----another issue which may or may not be the case is polarity via house wiring----have you had any recent issues with your wiring----wire changing and or service entrance---utility pole replacement----storms---lightning---these are things that can drive electronics nuts with out knowing it---this is all I can think of at the moment---get back to me with more info if you can

Maytag Neptune... | Answered on Feb 25, 2015


http://www.fixya.com/answer/answerpageslideview.aspx?thid=25326630

Let me know if this helps :)

Maytag Neptune... | Answered on Dec 18, 2014

Not finding what you are looking for?
Maytag Neptune MDE5500AY Electric Dryer Logo

2,008 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Dryers Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Brad Brown

Level 3 Expert

18154 Answers

Are you a Maytag Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Maytag Dryers

  • Maytag Dryers

Most Popular Question

dryer chirping along following start

  • Dryers
Loading...