Maytag Neptune MAH5500B Front Load Washer - Page 4 - Answered Questions & Fixed issues
How can this work I ohm this out it was ok the celilnoild
when unplugged? indicates its the water inlet valve, check it with meter and it may seem good electronically however it may still be bad manually. even though u get an OHM reading. at times it may fluctuate or not put out enough current.
Frequent LR code, need complete troubleshooting proc. advanced
LR code is usually caused my the motor and motor control board. if you have 120v to the motor control board and remove the multi pin connector and see if the motor goes in to a 50rpm spin. But more than likely it is those 2 parts. If the tub is noisy or hard to turn in spin motion it may be a bad rear bearing putting strain on the motor also.
Why the water wont come in the washer ,and the door stayed lock
Because the cycle hasn"t get to the point yet were the water need to pump in to the washer so you have to leave the washer on to work it self. u might have mistakenly stopped the washer yourself after u turned it on or something else is wrong and u have to give us some more info on what's going on . Now let just try this and see if ur washer will work.
Let restart the whole process again, the normal way u start ur laundry,
1, Turn washer off ( Like you're done washing )
2, Now put a new load into the washer, check all button to make sure they are in the right position then turn washer on.
Still not working. Then we need some more info or you need to call someone to take a look at it .
Washer tub not draining after spin cycle
Is it spinning but not pumping out the water? If so, I would make the suggestion that you have something stuck in the pump. I have worked on many different washers and if it's not the timer, the pump is the issue.
Error code 06 F or a nepturne washer
the 06 code refairs to motor problem or mcu control board,i assume the machine is not turning this is because a wire has come apart from the motor, or the mcu board needs replaced as it can no longer read the signal from the motor.adrian,,,,
Standing water in the barrel
Unfortunatly this is normal for the neptune washers and there is no solution other than to use the machine often so the water does not stagnate.
Not finding what you are looking for?