20 Most Recent Maytag LSE7806A Top Load Stacked Washer/Dryer - Page 4 Questions & Answers


check for the pump belt broken or off,clogged pump or sock or small item clogging the tub outlet to pump hose. the pump pulley may have become loose on the shaft also

Maytag LSE7806A... | Answered on Mar 01, 2013


It is possible that the machine does not start off the cycle because there are errors due to feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven starting from the flow of water into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect.

If the water flows though the inlet then the flow pressure should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor for rinse and wash.

Test a pressure switch: Click on : http://www.youtube.com/watch?v=HZZ2bDMspj8

Check this link to replace the inlet valve:

http://www.espares.co.uk/advice/washing-machines/a/7/1408/how-to-replace-the-inlet-valve-on-a-washer-dr.html

Finally after the wash the drain valve will be activated, the water is allowed to come in to rinse and then finally the dry spin with the drain valve/pump activated so as to drain off all the water from the clothes during the spin.

Make sure that a fault in any of the cycle will relate to the specified action, so check the command from the program module and then the executing device be it the valve or motor or pump.

Please check the link below:

http://www.repairclinic.com/Washing-Machine-Troubleshooting?red=Washing-Machine-Repair-Help

Maytag LSE7806A... | Answered on Jan 25, 2013


You need to replace the lid switch. Here is the part to order.

Maytag LSE7806A... | Answered on Nov 11, 2012


Let the draining out hose in a lower surface than the washing machine placed surface. Also check for any blockage in the draining hose.

Maytag LSE7806A... | Answered on Oct 27, 2012


I discovered that the risne cup dispenser holder will pull off letting you clean out the inside. Why they don't show this in the manual is beyond me. And by the way, what came out was gross and obviously you need to clean this frequently.

Maytag LSE7806A... | Answered on Aug 14, 2012

Not finding what you are looking for?
Maytag LSE7806A Top Load Stacked Washer/Dryer Logo

434 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Maytag Washing Machines

  • Maytag Washing Machines

Most Popular Question

model lse7806ace maytag stackable

  • Washing Machines
Loading...