Maytag Atlantis MAV7551 Top Load Washer - Answered Questions & Fixed issues
Water leaks from the bottom
Main seal faulty, pump seal faulty, tub to pump hose faulty, outlet hose faulty, hole in plastic outer bowl.
Washing machine make noise and I need help to open
Hello, Thank You for using FixYa. I will be helping you today.There is a clip about 4 inches in from each corner between the top and front panel. You need to push in with a putty knife and lift on the top, When top is open there are two screws one on each side holding the front on remove them and lift front off.
Thank You and please rate my answer if it was helpful..
Washer spins on delicate only. Won't spin on
Hello, Does it sound like its spinning in regular and just not spinning? If So You may just need to replace the belt. Also this unit the motor pulley would melt and break. Lean the unit back and you can see the belt and pulley. Hope this helps and please dont forget to rate me. Thank You...
I think my daugther's retainer is stuck under the
If this is a Maytag Atlantis model washer, just follow these steps to remove the agitator:
1. Remove the center post cap and softener dispenser by pulling it off.
2. Locate the agitator bolt under the center post cap and loosen.
3. With the agitator bolt removed, lift up on the agitator by grabbing the bottom flange.
If the model number is incorrect, please post back with your correct information. I hope this helps you.
Not finding what you are looking for?