20 Most Recent Maytag Neptune Washer - Page 3 Questions & Answers

Check any pump filter and outlet hose for blockages, if all is ok check pump.
I hope I have been of help but please do not hesitate to ask if you have any further questions.

I appreciate your vote if you appreciate my reply and remember, even if you don't vote for me a please and thank you goes a long way

had similiar problem , there was a piece of clothing stuck in a drain hose

if you can get to the valve, disconnect the molex to the solenoid and if the water stops you have a control problem if it does not then the valve is bad

this is most likely to be upper control board/located in the top of dryer

What is the complete model number of your unit?

Hi and welcome to FixYa, I am Kelly. It is possible that the coin drop acceptor is dirty. See page 22 of this manual:
http://www.fowlercompanies.com/SM/Maytag%20Service%20Manuals/MAH21SERVICE.pdf.
On page 23 there is also a guide rail adjustment.
The processor will pretty much go into a tamper proof mode that will not accept any coins you input if there is a problem with the sensor bar or guide rail. I suspect you have a guide rail that needs adjustment. The manual explains the adjustment procedure on page 23.
Thanks for choosing FixYa,
Kelly

It is a common fault that the drain fails to work in most machines in a period of time and is the most problematic fault in a washing machine. In all occasions it is important that your observation is most important and so is vital to the identification /rectification and solution. If you have noticed that water has leaked then as the drain hose pump/valve and fittings are located on the underside of the machine it is important that you look for possible leaks here. In some cases the drain hose would be clogged at the drain end to outlet of the house and so there will be back flushing resulting in overflow to the outside. Also the drain pump/valve can be clogged. Now remove the drain hose clamps and remove the drain pump/valve, clean the drain pump/valve, use back flushing to clear off all dirt. Now test using power to see if this works and can be simulated. When refitting, the hose must be tightened properly. If the pump/valve does not work even with power then it must be replaced. If there is intermittent power to the drain valve/pump then the program controller unit is a suspect.

Cleaning a pump: http://www.youtube.com/watch?v=zKjKi50YBpI&NR=1&feature=fvwp

Finally the washer must be placed with a tilt- use a spirit level- so that all water will drain to the outlet port and thereby there is no residual water remaining.

Replacing the pump on a Bosch machine, please check this link for tips:

http://www.espares.co.uk/advice/washing-machines/a/7/1373/how-to-replace-the-pump-on-a-washing-machine-.html

It is possible that when the load is more the drive pulley slips and does not get to the set RPM. This can be due to many reasons and so it can be related to no drain of water and thus making the timer to count down. Check the drive by removing the bottom plate, roll it with your hands to check for friction.

What is the complete model number of your unit?

What is the model number of your unit?

What is the model number of the unit?

It sounds like the "repaired" main control board is still the issue with it being intermittent.

What is the model number?

What is the model number of the unit?

Here ya go!Manual