20 Most Recent
Maytag MAH6500 Neptune Front Loading Washer w/Built in Water Heater - Page 2 Questions & Answers
Maytag MAH6500
yes there is a control board at the back of the machine if it got wet it will be damaged and eventually the machine not might work at all its easier to call a repair man instead of all the trouble doing it your self and it is int costly at all
F3 E2 error code on my Maytag washing machine
I just had the same problem with my MayTag washing machine - F3 & E2 error codes.I cleaned out the drain trap then proceeded to remove the top and rear panels to check the Temperature Sensor. The sensor was tested with an Ohms meter and found to be working properly.I went over the wiring from the Temp Sensor and found that both black wires had been 'cut' under one of the zip ties near the bottom of the washer.I had to reconnect them with marretts and presto; the washer works perfectly again. If you encounter this same problem - be diligent in going over the wiring. I missed it the first time around.It's an easy fix for anyone who can strip a wire of the plastic coating.Good luck :)
My maytag neptune MAH6500 wont start. panel lights up but doesnt respond to any buttons,
It is
possible that the machine does not start off the cycle because there are errors
due to feedback from the inputs. For the program to start up the main program
controller must initiate the INLET/MOTOR/DRAIN
pump/ valve to open up and allow each function to be driven starting from
the flow of water into the drum as also the drain valve to open to exit the
water at the point of the program cycle. If this does not happen then the
voltage at the valve/motor/pump must be checked or the fault relates to no
voltage from the controller. This means
the controller is a suspect.
Drum not going around
Drive belt may be broken or slipped off or your motor brushes may be worn and need replacing.
Washer wont spin
peace,
ngfam1 at your service,
1- maybe the belt is loose stretched or broken
2- may be the coupling from the trans to the agitator is broken
You seem to need hands on service!
A&E FACTORY Service is pretty good and nation wide
24/7 answering appointment setup for !
1-800-905-9505
Bless You,
ngfam1
Please give me the best rating here at fixya.com before you sign off!
Not finding what you are looking for?