20 Most Recent
Panasonic TH-50PX60U 50 in. Plasma HDTV - Page 6 Questions & Answers
Panasonic th-50pz85u problem
My problem turned out to be silly but simple. I recently took my TV off the wall and mounted it on a stand alone platform. I snaked the power plug through the back tube and left too much tension at the entry point for power. If you leave the slightest tension the female connector will jiggle and it will shut off. It normally takes 3 minutes before you can retry and then the problem persists. Try allowing more slack and/or buying a new power connector to make sure the plug connects correctly. Good Luck!
1/23/2009 4:28:49 PM •
Panasonic...
•
Answered
on Jan 23, 2009
Colored verticle bars, some w/colored snow,picture is still on
It sounds to me like you have a bad plasma panel. Unfortunately you may now be in the market for a new TV if you are not under a warranty of some kind. That issue is unfortunately unrepairable because it requires you to replace the entire panel and therefore is not cost effective.
1/23/2009 4:34:06 AM •
Panasonic...
•
Answered
on Jan 23, 2009
No sound: Panasonic 50" plasma
This just happened to me - I called Panasonic. Turns out it was my digital cable box - I unplugged it, turned in back on, and the sound was back.
12/30/2008 8:17:51 PM •
Panasonic...
•
Answered
on Dec 30, 2008
4 blinking lights
I fixed it myself!
I bit the bullet and ordered a replacement Power Board for AUS$290 and swapped it out myself.
Only took ten minutes, most of that time was removing and replacing the 101 screws holding the back panel on!
Working fine again now.
I did sit the two boards side by side and noticed the new one had moved some of the micro components from the back of the board to the front plus some other small component changes.
If your handy with a screw driver and have some technical knowhow I recommend having a go at fixing it yourself as it wasn't hard and probably saved $200 in service charges (all this assuming you are out of warranty!)
10/27/2008 12:43:57 AM •
Panasonic...
•
Answered
on Oct 27, 2008
Th-50px70b
when doe s this happen on hd tv bad signal on antenna will cus ethat to happen heavey comprsed dvd bunred will also do it may need better antenna ok
10/6/2008 3:33:45 PM •
Panasonic...
•
Answered
on Oct 06, 2008
THIN BLACK LINE IN PANASONIC PLASMA SCREEN
If it is a cable...There are many(from 7-11)driver ribbon cable with horizontal driver chips mounted on them!!!! So if problem didn´t go away after fixing all cables...your plasma has died.
9/20/2008 6:44:14 AM •
Panasonic...
•
Answered
on Sep 20, 2008
Blinking red light
Same problem with TH-42PZ700U. Took the plug out of the powerstrip and stuck it in the wall outlet and no fix. I will call Panasonic tomorrow. Thinking it might be a heat issue, cause it has been working again after it cools down for 20 mins. Only had this unit since 10/4/07.
9/13/2008 3:30:12 PM •
Panasonic...
•
Answered
on Sep 13, 2008
TV Won't Turn On
Are you from US or Canada? I'm Panasonic authorized and allways Pana covered the warranty after 1 month from the expire date. Call Panasonic Viera service and tell them the story. I'm sure you'll get refound.
Anyway, a horizontal line doesn't mean the PDP is defective. It's one scan IC burned on the SU or SD board (depend where the line is). We allways replaced the SC bord each time SU or SD got burned. If after SD and SC replacement it still defective...yes the PDP has one scan line in short.
Call Viera and insist to get warranty. Let me know. Good luck!
8/11/2008 5:48:08 AM •
Panasonic...
•
Answered
on Aug 11, 2008
Black line across from side to side
A black line is caused when there is a bad contact at the connector where the screen connects to the side PCB's. Clean the flex and re-insert, if that does not help, it is possible for the flex to have and open circuit, for the side PCB's to be faulty or even the screen to be faulty.
5/31/2008 11:50:08 AM •
Panasonic...
•
Answered
on May 31, 2008
One side of screen is blurry
Each half of the scren has its own processor and driver circuits for driving the screen. It is possible that one circuit is malfunctioning, giving the above sympyoms. The set will have to be taken in to a service centre.
5/31/2008 11:45:55 AM •
Panasonic...
•
Answered
on May 31, 2008
BLACK LINE PLASMA TV
most likely this is your y or x sustain boards and if that does not fix it . it could your pdp panel cost varise on part . The cost of your pdp panel is very expesive this th has lots of problems. I would call your local tv shop and have them give you a estimate.First ask thme how much they charge for a estimate. good luck.
Thanks doctor video
5/17/2008 10:33:17 PM •
Panasonic...
•
Answered
on May 17, 2008
Top And Bottom Of Screen
If you are useing a cable box or satelight rec. Check the format that you have it adjusted to. If not adjuste the format of the tv. If that does not fix it, it will need to be adjusted by a tech.
5/17/2008 12:47:56 AM •
Panasonic...
•
Answered
on May 17, 2008
Sound won't work...
can you go to the input mode and change it?? try that and make sure everything is turn on ( dvd, cable box, sat box, etc.)
4/12/2008 1:57:03 AM •
Panasonic...
•
Answered
on Apr 12, 2008
Color calibration
I'm sure that there is a reset on the menu for the color, then you can set to your likings.
4/9/2008 2:53:22 AM •
Panasonic...
•
Answered
on Apr 09, 2008
Not finding what you are looking for?