20 Most Recent
HP LaserJet 3600n Printer - Page 2 Questions & Answers
Display showing error 59.C0
59.C0 ERROR
An error occurred with the developing separation-drive assembly.
1.Check that the following connectors on the driver PCA are seated correctly: J403, J405, J213.
2.Check that connector J1020 on the DC controller is seated correctly.
3.Check that connector J5008 on the fuser motor is seated correctly.
4.Replace the developing separation-drive assembly.
5.Replace the memory-controller PCA.
6.Replace the fuser.
Replace and reset fuser for hp 3600
I tried the reset fuser and your instructions do not work for the 3600n. reset supplies is under another category and new fuser kit is not an option?????
Cpr sensor out of range. Calibrating takes long. How can it be resolved?
immediatly below the fuser unit/ above the image transfer belt inside the covers are the colour calibration sensors- they have mylar windows which get coated over time- clean with isopropyl- the sensors are looking vertically down and are approx 5x15mm is size there is one sensor to the left and one to the right, if after cleaning these the error still exists- try replacing the ITB and try again
59 co error
59.xx error main motor failed to reach rotation speed in a given time:-
have you recently changed a toner cartridge? is it 3rd party?
remove all toner cartridges and then switch power on to printer - it should turn over then ask for toners to be inserted, if so the problem probably lies with a toner cartridge
if the toners prove to be ok then the issue may be the Developer lift plates ( front/rear) which tend to snap after a while not an expensive repair but time consuming..fuser units on this machine dont generally give main motor failures neither does the transfer belt. If I was attending this call I would definatly have a full set of spare toners and the dev lift plates to hand as this would most likely be the fix
Not finding what you are looking for?