Top 20 HP DesignJet 330 InkJet Printer Questions & Answers

unfortunatly the only fix is to replace the firmware chip itself which requires a new main PCA/formatter, I would suggest with the age of this unit that would be most difficult to get hold of and would probably cost more to repair than it would be to procure a 2nd hand more recent unit

A clog print head noozle sometimes the cause of this problem, so try to clean it and try plug again

Probably a bad trailing cable. I've seen it many times.

This indicates that either the black print cartridge is faulty, misplaced or missing. Try inserting a different black cartridge. Also firmly press the large green plunger fully down once, and then release it. The plunger should return to its original position. Then reset the printer and try printing again. If the problem persists try using a new black cartridge and primeit before use with the power on.

Guys

1. Thanks for coming up for air
2. We figured out the problem
3. It's a master panel board in the bottom right corner of the printer
4. At this time we will be throwing out this HP 330 and getting another

Thanks for your help.

Sounds like a partial power supply failure; the output for the motor drive(s) has failed. This may be a separate assembly but some covers may need to be removed to determine this. 

The same Ram can be found in old desktop computers, 486 is about the right time for a 16mb or 32mb RAM chip.

played with the set up procedure and it fixed itself. thx for the followup

see the driver are properly installed or if you can do litte bit of serviceing like add oil on the rod . bye

Change font.

check the catridges thier must be a mixing up of color when you were refilling the catridges

To solve issues visit https://support.hp.com/in-en/document/c04530811 to get quick support call our Toll-Free 1 888 224 4280

There are three ways of configuring IP address on any HP Printer: A.- Using the control panel B.- Using the web server C.- Using the Jet Admin Utility We'll deal with the contro panel setup. To access the contro panel menus 1. Press OK (Check Mark) button once to access MENUS. 2. Press Up Arrow or Down Arrow buttons to navigate the listings. 3. Press OK (Check Mark) button to select the appropriate option. 4. Press Return to return to the previous level. 5. Press OK (Check Mark) button to exit the menus So to configure IP address: Press Check Mark Navigate to the CONFIGURE DEVICE Menu using Down Arrow (the menu scrolls, so you may use any combination of Up/Down arrows) Navigate to the I/O Menu Navigate to the EIO 1 menu Navigate to TCP/IP Navigate to BootP entry Press Check to disable it (Off) Press return Navigate to IP Address, press Check Use Up/Down buttons to change the address, check to move between octets. When finished, press Return In the same way, enter Mask and Default Gateway Press Return until you are out of the Menus. Done

The dates are on the package for a reason. The ink dries out or changes viscosity over time and will likely clog the printhead. My advice is not to stock up on cartridges because of this problem. If you look online, you can find replacement chips or instructions on how to reset the chip on the cartridge.

run "clean heads" or replace color catrige.

If this is an HP LaserJet 5100, then the cartridge or the fuser need to be replaced.

79 errors are usually bad firmware that needs replaced or updated. Sometimes it is simply a bad print job being sent. Check to see if only one print job is causing this error, or if it happens with everything you try to print.

sounds like the service station siezed and the control circuit to the motor has burned out- common fault for this machine- unfortunately this means its cheaper to buy a new machine than it is to repair- sorry