20 Most Recent
- Page 8 Questions & Answers
I have H4 error on
For H4 enter the following codes # interrupt C interrupt 14 Start button twice For ch check whether all the doors(side door,front door) are closed.
#Kintu Dennis Kentus
on Feb 20, 2014
F2 04 Content Improper cartridge (Destination error, life cycle
Detail The destination of the machine differs from that
of the CRUM.
The life cycle information is other than "Not
Cause CRUM chip defect
Improper developing unit
Replace the CRUM chip.
Replace the developing unit.
The trade mark code of the CRUM differs.
The company code of the CRUM differs.
The boot program model code does not
coincide with the CRUM model code.
Type error When the CRUM type is other than genuine/
The machine destination differs from the
When an error value is included in the initial
check information. When the max. toner supply
time is 00.
When the print hard stop is 00.
Misc error When the Misc information is other than "Not
on Feb 13, 2014
Solution for SHARP AR 5127 error U2-40 call for service
This means that the cartridge's sensor is miscommunicating with the copier memory thus the code U2 -40. You should clean the inner sensor connector and the toner sensor of the spilled toner by low blower. Perform this code ;# , interrupt , C, Interrupt keys in that order and press 16 then Print key and the code will be cleared.
on Jan 29, 2014
H5-01 is caused by multiple jams at the exit. Try resetting via pressing clear, interupt, 0, interupt,14,1 start button.
on Jan 23, 2014
Afficharge u2-40 ar m276
I am guessing that you may have just replaced your toner cartridge. Remove the cartridge, switch the machine off and with the toner cartridge still out of the machine close the copiers front cover and turn the machine back on. This will reset the code and the machine should now ask you for the toner cartridge again. First of all give the cartridge a good shake and then refit it to the copier as normal. Hopefully your done, if not you may need to replace the cartridge and get a refund from your supplier as it may be faulty.
Follow me on Twitter @CDOS_Service
on Jan 19, 2014
Not finding what you are looking for?