Sharp AR-5316 Advanced Digital Imager Copier - Page 5 - Answered Questions & Fixed issues
Sharp ar 5600 maintenance reset
Use # * C * to access SIM mode.
Use SIM 1-1 to check the mirror reciprocating
operations.
When the mirror does not feed.
Check for disconnection of the scanner wire.
Check the harness and the connector between
the mirror motor and the MCU PWB.
Replace the mirror unit.
Replace the MCU PWB.
When the mirror does feed.
Use SIM 1-2 to check the mirror home position
sensor. I’m happy to help further over the phone at
https://www.6ya.com/expert/ethan_e84416e0b13809d2
Looking for installer
Installing the scanner/printer use software driver CD or download from the website for the correct operating system software of your computer.
Newton
Error code H/4
enter service code # interurpt c interupt , machine goes off then enter 14 then press print button. this will cancel error code H4.
F2 ERROR
F2 04 Content Improper cartridge (Destination error, life cycle
error)
Detail The destination of the machine differs from that
of the CRUM.
The life cycle information is other than "Not
used (FFh)."
Cause CRUM chip defect
Improper developing unit
Check
and
remedy
Replace the CRUM chip.
Replace the developing unit.
Identificat
ion error
The trade mark code of the CRUM differs.
The company code of the CRUM differs.
Model
error
The boot program model code does not
coincide with the CRUM model code.
Type error When the CRUM type is other than genuine/
conversion/production rotation.
Destinatio
n error
The machine destination differs from the
CRUM destination.
Data
abnormali
ty
When an error value is included in the initial
check information. When the max. toner supply
time is 00.
When the print hard stop is 00.
Misc error When the Misc information is other than "Not
used (FFh)
Call for service . code : F2
There are several F2 codes. If you press and hold the start / copy key the machine will show your sub code. Re-post quoting full code and we can try to help.
H5
H5-01 is caused by multiple jams at the exit. Try resetting via pressing clear, interupt, 0, interupt,14,1 start button.
Afficharge u2-40 ar m276
I am guessing that you may have just replaced your toner cartridge. Remove the cartridge, switch the machine off and with the toner cartridge still out of the machine close the copiers front cover and turn the machine back on. This will reset the code and the machine should now ask you for the toner cartridge again. First of all give the cartridge a good shake and then refit it to the copier as normal. Hopefully your done, if not you may need to replace the cartridge and get a refund from your supplier as it may be faulty.
Good luck
Follow me on Twitter @CDOS_Service
It display
Check the white area of document glass and clean it or the copy lamp is not lighting.
2h flashing on screen,won't print
heat roller problem , enter # ,interupt, c , interupt machine goes off and enter 14 then press print buttom. this might clear ur problem. if it repeat same h2 code. need to change thermister and enter above code 14 again
Not finding what you are looking for?