20 Most Recent
Kyocera Mita Km 3035, 4035, 5035 Fs9120dn, Fs9520dn - Page 3 Questions & Answers
Kyocera mita j11 error code
On most Kyocera Mita copiers a J-11 code indicates a possible paper jam when paper is being fed from drawer #1, but sometimes a J-11 will be indicated when the paper fails to feed from the drawer. Check the paper stops and paper guides in the drawer and make sure that they are flush against the paper, also cleaning the paper feed and pick-up rollers with a rag dampened with just plain water will help sometimes unless the rollers are completely worn out. If all this doesn't help you may have a paper feed clutch or lift motor that has failed.
Error code f46f
replace the driver and check the files your sending one or the other is corrupt.
How to remove shake the toner .
You don't need to shake the toner. You only need to shake the toner when you install a new one. Shaking the toner to make it last later can give the copier a false toner reading.
How to set toner mita km2030
Open front door and you will see the black toner cartridge on upper portion of it you will see color blue lever pull it up then pull out the empty toner cartridge then insert the new toner.
What does code c-6 indicate?
Press and hold the following buttons in the sequence below.
(1) Stop/clear, (2) start, (3) exposure lighter, (4) exposure darker, release the 4 buttons and press the stop/clear button again. the display should now indicate 000.
below the display are 3 buttons... press the left button once, the middle button 6 times, and the button on the right 3 times. the display should now indicate 163.... press the start button 3 times.
your machine will now restart, and if the code was as a result of a power problem, should now work fine. if not the problem could be related to the fixing unit, power supply, or one of the boards.
Also do not tamper with any settings while in the service mode, this WILL have undesired effects. TAKE NOTE, this will only work if your model is the KM-1500
How can I reset c-6 code?
press and hold the following buttons in the sequence below.
(1) Stop/clear, (2) start, (3) exposure lighter, (4) exposure darker, release the 4 buttons and press the stop/clear button again. the display should now indicate 000.
below the display are 3 buttons... press the left button once, the middle button 6 times, and the button on the right 3 times. the display should now indicate 163.... press the start button 3 times.
your machine will now restart, and if the code was as a result of a power problem, should now work fine. if not the problem could be related to the fixing unit, power supply, or one of the boards.
Also do not tamper with any settings while in the service mode, this WILL have undesired effects. TAKE NOTE, this will only work if your model is the KM-1500
Kyocera mita 6030
The optimizing performace may be because of the temperature in the room.Clean out all filters in the machine.Do not reset the drum light unless you do change the drum as the copy quality may degrade.
Not finding what you are looking for?