Kyocera Mita Km 3035, 4035, 5035 Fs9120dn, Fs9520dn - Answered Questions & Fixed issues
Kyocera km 5035 error c2500
Paper feed motor problem.Ensure that all cassettes are correctly loaded with paper.Ensure that by removing the paper cassettes no paper is jammed behind them/in the copier.press 1087 1087 on the key pad,then 906 then start,then execute then start.Press 001 to exit.
C0640
Hard disk drive problem
The hard disk cannot be accessed
the main PWB and the connector on the
hard disk. Repair or replace if necessary.
Defective hard
disk.
Run U024 (HDD formatting) without turning
the power off to initialize the hard disk.
Replace the hard disk drive and check for
correct operation if the problem is still
detected after initialization.
Defective main
PWB.
Replace the main PWB and check for correct
operation
How to fix system error c6050 on my km-3035
It is a fixing assembly error code. The thermistor doesn't detect heat. Kyocera you replace the fixing assembly. You may be able to reset.1087 1087 gets u into served mode go to reset and activate.power off and on.
Error code j6301
Adjust the finisher to the upper limits to resolve. The height from the factory is too low. Paper curl from moist paper will cause this jam code 6301.
11/30/2022 12:30:15 AM •
Kyocera Mita...
•
Answered
on Nov 30, 2022
•
649 views
Code c 610
You have not mentioned the modelThis error code means that the dim is at fault or requires re-seating into the machine.
10/7/2019 6:45:05 AM •
Kyocera Mita...
•
Answered
on Oct 07, 2019
•
86 views
Error c7400
Developing unit connector insertion
problem
Absence of the developing unit is
detected.
Developing unit
connector inserted
incorrectly.
Reinsert the developing unit connector if
necessary.
Defective developing
unit connector.
Replace the developing unit.
12/11/2017 9:54:13 AM •
Kyocera Mita...
•
Answered
on Dec 11, 2017
•
137 views
C4000 km 5050
Polygon motor synchronization problem
The polygon motor does not reach the
stable speed within 20 s of the START
signal turning on.
Check the connection of connector YC3 on
the engine PWB and laser scanner unit, and
the continuity across the connector terminals.
Repair or replace if necessary.
Defective polygon
motor.
Replace the laser scanner unit.
Defective engine
PWB.
Replace the engine PWB and check for correct
operation.
12/11/2017 9:45:29 AM •
Kyocera Mita...
•
Answered
on Dec 11, 2017
•
144 views
Not finding what you are looking for?