20 Most Recent Comfort-Aire BHD-501 Dehumidifier - Page 7 Questions & Answers

'make and model' are needed in all questions please. However it appears to be Noma or Hisense. See videos and articles. https://www.google.com/search?q=Dehumidifiers+error+E9 ..

posted 3 times an not add or edit the first, why? get the the manual from the makers web site and read it. or ask them for help or call for service

Check that the hose connection is secure and that there aren't any kinks or blockage in the hose. The hose should always slope downward not go vertical or in an upward direction. If the hose is clean and water flows out freely, check the placement of the unit. The unit not being level could be another factor as to why it's collecting water in the bucket and not out of the drain hose. Make sure that the unit is level. If there is a slight slope to the floor, adjust the unit so that the hose is closest to the drain. In units that were stored for the winter, for an extended period of time or in a highly dusty area, there may be grime build up in the main water outlet that connects to the drain accessories. Use a pipe cleaner to help clear the buildup by inserting the pipe cleaner in the main water outlet.

A dehumidifier is the same thing as a window unit air conditioner that you sit on your kitchen floor instead of installing it into a window. It will blow cold air out one side (evaporator side) and hot air out the other. (condenser side) Hot/Cold cancelling each other out, (plus a little bit of "extra" heat from running the thing) yet the evaporator STILL removes humidity from the air in the form of a puddle of water on your kitchen floor. They (air conditioners & dehumidifiers) are both essentially air conditioners only difference being is that in order to "cool" an area, the "condenser," or "hot" air would have to be moved outside somehow. Air conditioners do not "cool" air, per se. Instead, they ABSORB & MOVE HEAT from one place to another via some type of gas (freon) and a compressor pump inside of a closed tubular system. (copper,brass,aluminum, etc)

Question edited to add Dehumidifier details.No spares available. You can seal the threads with PTFE tape which make the threads thicker, or try and fix with epoxy resin. Or can you drill it out and put in a plumbing fitting. The threaded items should be a standard size.https://www.searspartsdirect.com/model/uffmiptp6v-001428/frigidaire-fdl50k1-dehumidifier-parts..

Thermostat probe sensor code

Hi! Please check the manual to Freidrich dehumidifier Appearance and Control panel Friedrich D70D User Manual Page 3 of 14

It appears to be a Humidity Sensor error. https://www.google.com/search?q=HiSense+30+Dehumidifier+F-9+error ..

see page 22 manual https://sps-support.honeywell.com/s/article/What-are-the-error-codes-in-an-E3-SA https://www.haierappliances.com/support/support-content/34659

Screws are normally hidden under the feet, under plastic plugs or under rounded screw covers. https://www.google.com/search?q=soleusair+hmt-d70eip-a+dehumidifier+leaks ..

It sounds like it needs servicing and recharging with refrigerant gas. It works by running the moist air over refrigerated elements where the moisture condenses and drips into the tank. Make sure you are on the right setting, most have 'blow air, remove moisture, and A/C'..

Page 18 of the manual says it is a 'parameter'. http://www.gullbergjansson.no/fileadmin/user_upload/Dokument/manualer/Avfuktare/Gullberg___Jansson_Manual_Avfuktare_till_inomhuspool_DP-serien.pdf Press CTRL+F and type 'C1' than press enter. There are 3 references to C1. ..

There are 6 rubber plugs in the top covering screws , 2 are all at hidden under the handle ends , the handle can be lifted to about 45 degrees and teased out an end at a time to gain access, the top then removes giving access to more screws which when removed along with screws under the bottom and inside the tank compartment allow the front and back to be removed for access

google MDK-65AEN1-BA9 manual they are readily available

normal it is an AC not dehumidifier. there is no humidity sensor, it operated on room temp not humidity. https://www.manualslib.com/manual/1015047/Challenge-414-0038.html#manual

cont button just means continuous run mode . the power light is lit , the full light is out . try reseating the water catch bucket a few times , most machines have a safety that wont allow the thing to operate if bucket isn't just perfect in its slot (you don't want water on your floor )

sadly we have no service manual to find out .Check with Edison