20 Most Recent Ricoh Aficio SP C410DN Laser Printer - Page 3 Questions & Answers

Look at the toner hopper closely there are little springs that some times get caught "down" they line up with the contacts on the toner. -Carl

When starting the printing job (Command P), open settings of the printer before start printing. On every type of printer, somewhere you will find an option to print grayscale/black&white

Replace fuser unit. Be sure you are setting the paper type when printing. Thicker paper requires more heat and will damage the fuser.

Ok that's the issue...It means that there might be debris on the laser glass blocking sections of the laser from striking the drum. You should have a cleaning wand (light blue in color) in the door as you open it. Remove the waste toner bottle to access the four slots that are just beside each drum. Insert the cloth end into each slot pushing it all the way in and out twice per slot. If this does not correct the problem. You may have to do individual colour print tests to determine which drum may be defective.

Sorry, I'm not sure what you're trying to tell me. That there is a white stick stuck in the machine or you're using very low grade paper with hunks of wood floating in it?Would you please re-state the problem with more detailed information.

That code requires going into the SP (Service Protocol) mode. If you have the service manual, it will tell you which buttons to press to enter it and to exit service mode. Once you enter service mode, power down the printer. If that doesn't reset, you have to go back into service mode, go the the SC/Fuser reset SP and once executed, power down then restart. Hint: you have to go to "SERVICE" then 1 will display. Press the right arrow key until you reach "5" then press the OK button. You can then right or left arrow until you find the reset SP. Good Luck.

DEAR SABER, IT SHOW THE MACHINE TERMISTOR HAD TO BE REPLACED ,LATER after replacing it, you had to reset the machine in sp mode

Reset the job and reset the device.An error has occurred in printing.

1. Make a note of the error message (for reference later).
2. If the error re-appears, please contact your local authorized sales/service representative or original point of purchase.

For the time being, try restarting the device:

1. Press the Clear button to clear any pending jobs from the Printer.
2. Switch off the device at the Red Power Switch, wait for 5 seconds then switch on again.