Samsung CLP 300 Laser Printer - Answered Questions & Fixed issues
CLP 300 crumpling lower right hand side of paper
There is a foreign object in the paper feed path. It could be anything from a paper clip or staple through to an insect (or worse). It will definitely be on the side where the crumpling occurs. Try feeding a strip of card or thin flexible plastic backwards through the feed mechanism. A laminated sheet of paper can also be effective for this.
LINES
The LSU is the Laser Scanning Unit.
You have to take out the Image Drum, The hole Unit wehre the toner is installed in. There's a green latch you have to pull and then take it out of the printer. Now you have to look inside the printer. On the ground is a small shutter, you have to pusch it to the rear side and hold it there. Under the shutter is the LSU. Now you can clean it with a non-fuzzing cloth.
Hope i can help you.
Greetings from Germany
I have a Samsung that say Transfer Belt Error
Hi
I have a utility to reset the consumables errors on this printer, but only if the component is past its lifecount. (60k for transfer belt)
Its called CLP-300_Reset_RLCv04.exe or just RLCV-04.exe (if you can find a copy)
If you need a copy, let me know and I'll find some way to get it to you.
I've used it for transfer belt reset and it works.
Find the waste toner for Samsung clp 330
Open the front of the printer, and you will see the four toner drums; cyan, magenta, yellow and black. Immediately to the left of the cyan drum there is an "L" shaped drawer : That's the waste toner drawer. It pulls straight out. If you enjoy driving around and spending money, you can buy a new one. If you are frugal and practical empty it as follows:
To do this cleanly I recommend wearing a pair of latex gloves! At the top of the container there is a square opening with gray foam on the inside edges - this is where the toner can be dumped out. Take an empty bread or bagel bag and put it over the end of the cartridge far enough to cover that square hole plus another inch. Gather the end of the bag and secure it with a rubber band or tape making sure the hole of the cartridge is INSIDE but not taped shut, and the bag's edges are properly sealed. Now you can turn the cartridge upside down and agitate it in different positions until all the toner is dumped into the bag. Flick the bag with your fingers to let the toner fall to the bottom, them put around the bag to keep all the toner at the bottom, and carefully remove the tape or elastic. Using a lightly moistened paper towel clean up the cartridge and reinsert it into the printer.
Now if you haven't left too much air in the bag gently take the end with all the toner in your palm, gather the rest of the bad with it into a small ball in your fist and pull your glove off over the whole lot. take that in your other hand and remove that glove.
Voila! The cleanest toner dumping ever!
When i connect my printer
There is a lot of problems that can cause the light to turn red, such as paper jam, low toner, full waste toner tank, etc. The only real way to know what the printer is detecting is to use the smartpanel utility program. It should be able to tell you what the printer fault.
Fix samsung clp300 printer
I played around with mine for a few weeks and could not find a simple fix. The printer was GREAT, until it wasn't. Repair cost was more than replacement, so it was time for a new printer. I sold my extra ink carts on CL. Sorry this isn't much help....
How to clean printer head
there is no print head in this model is a laser printer with drum
1-check toner level and the setting of toner density in setup.
2-remove toner cartridge and clean entire printer with air blower
3-replace toner cartridge
Not finding what you are looking for?