Sony BRAVIA KDL-40V2500 40 in. LCD HDTV - Page 8 - Answered Questions & Fixed issues
I have a 40inch Sony Bravia and all of a sudden I
This tv have a dead board call the T-CON decoders board.This board sit right at the bottom at the middle of the LCD screen panel.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish T-CON decoders board for the replacement.
10/29/2010 11:13:53 PM •
Sony BRAVIA...
•
Answered
on Oct 29, 2010
•
1,328 views
I have 2 wide shadow
The symptom im afraid sounds like a defective panel. After the set has been on for several minutes say at least 10 minutes. Try giving it love taps... along the top of the tv where the bars are visible. If they get better or worse while tapping then your panel is failing. Replacing the panel usually cost more than buying a new set. If it has no effect what so ever then you could be dealing with a bad t-con board which is available at shopjimmy.com for around 60.00. GOOD LUCK!!!
10/19/2010 4:40:22 AM •
Sony BRAVIA...
•
Answered
on Oct 19, 2010
•
130 views
The picture is too big
Press Zoom button repeatedly on tv remote to get correct Screen Aspect Ratio that you want to see.
10/13/2010 12:02:45 AM •
Sony BRAVIA...
•
Answered
on Oct 13, 2010
•
251 views
Sony lcd tv model KDL-40S2000
That is almost always an indication of main-board failure on these Bravia LCD's. Unfortunately this is a very difficult repair, and unless you are an
electrician I would not recommend attempting it. You will need to
contact a local TV repair person in your area. If you think it may
still be under warranty please contact the manufacturer to file an
RMA. If you happened to purchase the TV with a major credit card (not
a debit card) there is a good chance it may still be under the free
extended warranty most credit cards place on electronics. Please
contact your credit card company to inquire if they do this, and they
will be able to file the claim and get you a refund for the TV.
Let me know if you want me to try and track down the part for you, but please make sure you think you are capable of doing the repair.
Thanks
Tim
10/7/2010 3:13:46 AM •
Sony BRAVIA...
•
Answered
on Oct 07, 2010
•
610 views
Ok this happeneds about everynow
The tv now turn on have flicker of picture few sec.than died,have sound left only?Yes,than the 2 long boards call the LCD inverter boards are dead.These 2 long LCD inverter boards help the LCD screen to have a backlight to produced a picture.Tries websites like Shopjimmy.com,Ebay.com to buy those 2 refurbishes long LCD inverter boards for the replacement.
9/9/2010 7:46:24 PM •
Sony BRAVIA...
•
Answered
on Sep 09, 2010
•
91 views
HOW TO CONNECT SONY BRAVIA
Howdy, many of the Bravia line have a VGA cable input that matches the cable on your PC monitor. This cable is available in varying (too short) lengths from any electronics department or shop.
Thanks for using fixYa,
Farmerbear
9/2/2010 5:27:05 AM •
Sony BRAVIA...
•
Answered
on Sep 02, 2010
•
389 views
Sony Bravia 40
go to your remote contol ( menu )
then you go to the option set up.
then you go to headphones and you can set the volume louder.
You will see that it works fine.
Greetings from Holland Gesinus
8/15/2010 11:28:15 AM •
Sony BRAVIA...
•
Answered
on Aug 15, 2010
•
813 views
Kdl 37N4000 Red light flashes 2 x's wont turn on
Hello,
Your power supply board is dead, u know basic electronics’ and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.
Hope this helpout....
8/13/2010 9:31:58 AM •
Sony BRAVIA...
•
Answered
on Aug 13, 2010
•
179 views
Stand by button flashes after turning on TV
Hello,
Ur power supply board is dead, u know basic electronics’ and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get ur tv power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.
Good luck...
8/8/2010 1:24:02 PM •
Sony BRAVIA...
•
Answered
on Aug 08, 2010
•
152 views
I can hear audio but cannot see anything on my tv
First, look at the screen in darkened room to see if you can see any slight glow from the screen, if it does, then the problem can be the T-CON (not getting the 12vdc) or the main logic board not feeding the signals to the T-CON board.
if not, next place to check will be the power supply module, make sure it has 24vdc which is required by the backlight inverter to work, the reason for not having 24vdc can be from bad DC filter caps (leaking/bulging top, high ESR) or short circuits in the inverter board which will cause the 24vdc supply to go into shutdown mode, so you may have to disconnect the power cable that feed the inverter board to see if the 24vdc will work without the inverter board hookup, you will need to apply about 3~4 amp of load to the 24vdc to make sure it can handle that. There are fuses on the backlight inverter boards also. So there are some troubleshoot you will have to do to find out the causes of the problem you are having.
If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:
Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://s807.photobucket.com/home/budm/allalbums
http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx
Please post back what you find.
8/1/2010 4:14:38 AM •
Sony BRAVIA...
•
Answered
on Aug 01, 2010
•
855 views
How do i adjust the
The wide button on your remote adjusts the picture size. Each time you press it you adjust the picture. If repeatedly pressing the wide button is not changing the picture size check you cable/satellite remote control. Look for the hdzoom# button. There may also be an aspect or format button. When you adjust this the picture size changes and between the Sony remote and the cable/satellite remote you should be able to come to a happy medium. If the picture size still isn't changing you might not be set to the correct resolution i.e. 1080i on your cable/satellite box. It might be set too low or you might be in the wrong input (av 1 av 2 hdmi 1 hdmi 2) etc.
7/7/2010 4:37:27 PM •
Sony BRAVIA...
•
Answered
on Jul 07, 2010
•
3,514 views
Not finding what you are looking for?