Ricoh Aficio SP-C210SF Printer - Answered Questions & Fixed issues

The default password is stated in the webinterface when you click on the red or green key default admin username is "admin" and the password is "access"

sounds to me you are using the "wrong driver" double check the driver and the OS you are using.

I would also turn the printer off and clear all print jobs from the print que and restart. After loading the new driver do a test page from the driver.

So go the system setting and reset the printer it will be ok.. If you cannot do it just call service centre.

Seems its fuser assembly fault. Fuser assembly is a part to fix toner image permenentely with the help of hot rollers on media. The temparature varie depends on model, in case the temparature not reachess specified level you may get image fixation problem, the same what you are facing. Replace fuser assembly.

Wonderful detail! Good luck with that

I THINK THE NUMBERS BUTTON HAD PROBLEM, TRY TO CHANGE THE NUMBERS BOARD & SEE IF THE PATTERN STILL PERSIST. IF THE PATTERN PERSIST ALTHOUGH YOU INSERTED NEW NUMBER BOARD, THEN YOU HAS TO GO IN SP MODE TO CHANGE PRINT SETTING

You may download the Ricoh driver from http://support.ricoh.com/bb/html/dr_ut_e/re/model/spc210/spc210ge.htm

Unable to print troubleshooting and routine maintanance chapter in user's guide

WE HAVE RICOH PRINTER SP 1100SF & REPLACED CARTRIDGE WITH NEW RECYCLED BLACK TONNER CARTRIDGE FROM POWER POINT, BUT UNABLE TO PRINT AS CHIP GIVEN IS NOT ACCEPTED BY PRINTER. TRIED 3 DIFFERENT CHIPS STILL PROBLEM PERSISTS. WHAT MAY BE THE RESEASON AND SOLUTION

You can install the SOM (Smart Organizing Monitor), it is a utility which can check the status of a printer and set up a printerfrom a PC. This utility is executed from a printer driver.Start the SOM to see the status of your printer..

It is the drum assembly.

If you lift the document feeder, you will see a narrow piece of glass on the left side. Originals are scanned across this when the feeder is used, so a small speck of dirt becomes a line when copying. clean the glass, and it should be good to go.

I think its included in the manual.


http://www.pacificos.com.au/PDF/SP%20C210SF.pdf

Refer to your user manual for the correct way to insert the ink toner, or ring the manufacturer's customer service line.
Hope this helps

Steven Cumming
Please leave postive feedback :-)

your cartriage need to clean, bunker is full.

Check out this link for your printer drivers. Check you win 7 version (32 or 64 bit) and it will provide a download link for the driver.

error insert tonner card

Clean the seperation pad on the tray and rollers you see when you take the paper tray out, use a damp cloth with a dab of dish detergent.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response

Thanks, Joe I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

it could be the photoconductor belt which is worn out. its no use replacing photoconductor belt as its around $1000. my advise will be to change the whole printer. SPC210SF is not a good printer. it has alot of problems and its very noisy. I work in Ricoh.

Hi

You need to replace your cartridges with new ones