Amana AKS3040 Gas Cooktop - Page 7 - Answered Questions & Fixed issues

I certainly won't tell you that your cooktop is OK to use (both because I have not seen it and because I don't want to be sued by your grieving family), but there is nothing mystic about this. Electrocution can only happen if you come in contact with an electrically conductive part that is not grounded (which includes water that is in contact with a metal part inside the cooktop). The fact that the glass is cracked makes it more likely that you, or spilled pan contents, could reach a dangerous part inside the cooktop, that is all. Manufacturers' instructions are generally very conservative.

Ignore pupahecud - one of many FIXYA fraudulent spammers. Contact Eurolinx ILVE for assistance - see the link below for phone numbers in your country. https://manuals.appliancesonline.com.au/pe90wmpss/pe90wmpss.pdf

Two things to try. Either unplug it or turn it off at the breaker.. Clean the cook top control area and allow it to dry overnight. You can turn the power back on after cleaning ideally. In the morning, with the power resumed just wipe the control area off with your bare clean hand.

I have no idea why this worked for me, but it did. Good luck.
If that fails, you can look up error codes or schedule a repair.

5 year warranty on the unit.

Are you using the induction pans.

Check if any button is pushed in in a weird way or if there's a lot of dirt around the buttons. Please clean around the buttons as far as possible. The problem should be fixed then.

Try googling it

Dear sir, I tried it but not work on schott ceran 9000309592. Regards,

Check to see if your ignition button in stuck down. Also look to see if the ignition wires have a bare spot and is shorting out.

Check your warranty you may be able to get someone to come out and have a look, and possibly replace it under warranty.

Bad switch or bad heating element, or, less likely, a loose wire.

Turn off the cooktop at the power supply. Leave off for 15 minutes and try again. If it reoccurs, something failed when the power went off. Schott Ceran is the Manufacturer and type of glass the cooktop has. You will need to get the name of the cooktop manufacturer and the model number. There should be a sticker underneath the cooktop with these details.

Consult owners manual

Try downloading the manual online,usually works for me

Have you tested the fuses with a multimeter? Sometimes they look ok when they,re not. Using the multimeter trace the wiring till you find where it stops, it may be a fusible link that's encased in a fibreglass sheath. Good luck and be very careful when it's live.

Will have to be disassembled to access burners.

What type of cook top?

[email protected]

Contact defy for installation instructions for your model

circuit board error