Top 20
Dewalt DC920KA Heavy Duty Xrp 18V Cordless Drill/Driver - Page 7 Questions & Answers
How do you change a
position the drill to speed one & drill mode.u need a allen key then clamp it the chuck jaw close & tight. hit the allen key with hammer counter clockwise until its loosen. may have to do it any several times.
How much Voltage?
a higher voltage means more drilling power but it can also mean more weight - don't buy a drill you won't need, 12 volt drills are powerful enough for most home users, bigger models just weigh more so think carefully about what you will be using the drill for.
Drill chuck swap
1. Turn the screw clockwise to take it out.
2. Then you needs 3/8 allen key & insert the short side of the allen key & tighten the chuck.
3. hold the drill at the edge of the table & wack the allen key
counter clockwise & do it again as needed.
4. dewalt keyless chuck will fit but you might add a washer to insure the chuck is not rubbing the clutch collar.
5. putting it back together the other way.
I have two 18 volt
the charger rearly fail. it must be the battery problem.have your battery tested also the switch of the drill.if the drill runs slower than use to be changed the switch.
New grease gun, never used.
may not be a solution, just an idea
but the switch shits actual gears, the splines may not be aligned enough to allow the transfer.
put it back in low, run the motor a few revolutions to change the alignment of the gears, then try the shift again, like a crash box on a model T
How do you change a
u need allen key that fit to the chuck. insert the short end to the chuck. tighten the chuck if u can. hold the drill at the edge of the table & smack the allen key counter clockwise. do it again if needed. but before u do it set the speed to #1 position & drill mode.thanx good luck
Hamer drill xrp
if the battery are less than a yr old should be a warranty
if drill DC920 or DC925 they are on recall for switch. may be co'z the battery to die. have them check at ur nearest service center.
I think its a bad chuck unsure though
yeah you have a bad chuck. there is a screw inside the receiver of the chuck if you remove this screw the chuck will come off. Reverse this procedure to re install the new chuck.
Transmission problem
front of the trans had a pin the spring is inside. if theres no tension maybe missing spring or the large out crown gear are worn. you can get the trans in assy,
Chuck will not release bit
Hi,
the Chuck should be 2 Part.
Use 2 pair of stillsons Or pipe wrenches, Tight On the 2 Chuck Parts, Crack in opposite Directions.
Alternative, Use Wrench On Chuck Jaw, Short sharp Blow With Hammer.
Mike @ compurepair.
I want a black&decked battery
the charger its self are expensive.better to purchase new unit for a couple dollars more & u have 2 spare battery & charger
Not finding what you are looking for?