20 Most Recent
Mettler Toledo - RM40 - LiquiPhysics Excellence Benchtop - Page 6 Questions & Answers
Salter 9001 bathroom scale stopped working
Hi Pete. I don't keep receipts either : ^ )
No that I am done commeserating, try this. Remove the batteries. Use the eraser end of a common pencil to scrub and clean the battery contacts inside the battery compartment. Also pull the contacts a little closer to the surface if you can. Then reinstall the batteries and you may be up and running.
Please rate my answer as verey helpful thanks. Joe
MD-3006SS Metal Detector will not tune
I had the exact same problem and after messing around with it for about half an hour I realized that the cord was the problem, I was kind of moving it around while plugged in and if I hold the end of the cord in a certain direction it works like it should. If the results are the same for you, I suggest either getting a replacement cord or just do the not so reliable option and tape the cord into place.
Sharp Atomic Clock SPC-373. The outdoor sensor on Model spc373 not working
It is a known issue
Try first a general reset:
- remove the batteries from the clock (thus turning it Off.)
- remove the batteries from the outside sensor (if you are not aware that it has batteries, then perhaps it is not working because the batteries are no good any more! check that also.)
- wait 10 minutes with no power to the device.
- put batteries back in, power On again.
- hit Reset.
- hit Receive button.
- change the channel for reception from the outside sensor.
- change the channel on the outside sensor to match that channel.
- then set the time once more, once the remote temperature is sensed once again.
If this does not get the outside temperature reading working again, you may have to replace that temperature sensor.
https://www.google.com/search?q=Model+spc373
..
Sokkia PL 100 pipe laser showing error code
Hi I know it is 2 years too late but I thought I would write the solution for otherspress the up the down and the on/off but all together after a few seconds CAL 3 will appear and the lser turns off.turn the laser back on again and it should be reset to 0.00 procent-you need to calibrate the laser now using the same methodhope this helps Dale
Not finding what you are looking for?