20 Most Recent
Maytag EPIC MFW9700S Front Load Washer - Page 6 Questions & Answers
Washer display flashing error code f-21
The F21 code on the Maytag EPIC is telling you there is a pump problem.
The pump impellers should be checked. There should be four of them.
Sometimes the impeller blades can be broken by coins, etc.
Make sure that the pump is clear of debris, to do this:
Remove the discharge hose, and blow through it.
If after clearing of water, the hose doesn't blow free and clear, you have something stuck in there.
You will need to clear the pump of the item that is stuck inside.
Good Luck,
I hope this helps,
Please rate me,
Thank you
Won't drain and showing F 01
Good Day,
Your
washing machine is fully automatic?
the
washing cycle is normal?
if yes
do the same maybe it will help you.
for
the fully automatic washing machine mostly have drain pump, please check the
filter of your drain pump, how? remove the cup of your drain pump like a
ordinary cup, screw it clock wise or counter clock wise.
Remove
drain pump filter and clean it, some hair pins, cotton buds or coins or any
small item that coz of clog up.
if
your washing machine dont have drain pump ,but fully automatic check the drain
motor if running or not? how? open the back cover for top loader washing
machine only, select spin cycle and press start to see the drain motor running?
the drain motor is like a small box with small wire to pull the lever of the
drain to remove water inside, if the motor running or pull the lever of the
water pipe but water still inside the washing machine, remove the drain cup or
cover and clean it or check if have coin or cloth inside that coz of clog or
water stuck,
if the
drain pump or drain motor is weak this is will cause and long time draining or
totally not running the drain pump or drain motor and its cause of totally stop
the cycle of washing machine in rinse time or spin time, because all fully
automatic washing machine, after washing cycle the drain pump or drain motor
must be on, to remove water before start the next cycle. rinse or spin cycle.
I have a Maytag Epic Z400T. Front panel goes
Possible that there is problem with the power supply to your main board unit, It is possible that the DC converter is having a low regulation and so when the start is pressed on there is a drain on the power resulting in the panel showing a DIM. Check the motor, remove power and check for overload to motor and inlet and drain pump
No realiza los ciclos
for the machine to work you have to have power and water pressure coming into the machine. if the machine doesn't fill with water you may have a bad water supply valve. this is located where you attach the hoses to the back of the machine. Cheers Denny
My maytag epic z is leaking from underneath
Remove the front bottom panel. Should be three 1/4" screws on bottom lip of panel. See if you can tell where leak originated. Chances are good you just need to pop the cap off the drain pump and clean it out. Here is a vid that explains the procedure.http://www.youtube.com/watch?v=iLftnaruKp8
Drain wont drain on a epic washer where is the
The
drain filter is located in the pump behind front bottom panel. Disconnect power and remove
the three screws attaching the lower front access panel to the cabinet
then pull the panel down and off the cabinet. You can prop up the bottom
front edge of the washer or cushion and lean it against the wall to
access and remove the screws more easily. Once the panel is off,
remove the filter by turning the knob counterclockwise. Clean the filter
from any debris that prevents water from draining out properly.
Not finding what you are looking for?