20 Most Recent Maytag EPIC MFW9700S Front Load Washer - Page 7 Questions & Answers

to clean this maytag This video will show you how to keep your soap draw clear and how to service the parts Please remember to subscribe to our YouTube channel for all appliance tutorials a 4 THUMBS rating is appreciated for answering your FREE question.

Take a look at this link for information on your F21 error.

Aha Heater or temp sensor failure. Yer water temp sensor or your heater has failed.




I have yer Epic Z Service Manual right ova Heah If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

this is a child safety lock feature to keep them from turning on and off the machine, you must hold down the cycle end button for 3 seconds to unlock the machine, you will find these instructions labeled right on the machine and in your owners manual.

Suggestion: Refer to your manual to clean your filter, it is normally located at that place.

They have cleaners available that will cure this problem.

First try turning off the machine for 30 minutes. Then check your inlet valve. Shut off valve, switch off machine & see if the water comes full flow. Check the filters on the machine inlet entry, they could be blocked, clean out.

The FH indicates a fill failure and this is usually caused by a bad water valve, flow meter or pressure switch.

One key to determining the cause of the FH error is how fast the error comes up in a cycle. If the error appears within 1 or 2 minutes then the most likely cause will be the water valve or flow meter.

If the error doesn't appear for several minutes then the pressure switch can be the source of the problem.

Both water valves must be turned on and working. Even if a cold wash is selected at some point during the fill the hot water valve will be energized and if there is no water then the FH error will show up. Sometimes a consumer will turn the hot water valve off to save energy but you can't turn one valve off on this washer.

Inlet valves can be purchased thru the net and fitted by you easily.

F28 is a communication error which usually means there is a connection that has come loose.Check the wires on the control board.