20 Most Recent LG WM0642H - Page 5 Questions & Answers

think logic stuff made in turkie

drum has to b removed then split

The dE error or fault code indicates that the door is not latching properly. Check the lid or door operation to be sure it's not binding and that the door alignment is correct. Also, check the door/lid hinges to be sure they're not binding. Finally, make sure the door catch is in place and not broken. You may need to replace the door hook/catch or the door lock assembly.

According to page 21 of the owner's manual, the following are known error codes: IE= Water Inlet Error, OE=Drain Error, UE=Unbalance Error, dE=Door Error, tE=Thermistor Error, FE=Overfill due to Faulty Water Valve, PE=Water Level Sensor Error, CE and LE=different Motor Errors, and PF=Power Failure. its a motor error check the brushes

The PDF Owner's Manual from Product Support contains error codes. It is not the exact same model but frequently the same product line uses similar components with similar error codes. Its worth a look anyway. Hope this helps.

The control panel has a problem, check it or replace it

Tell me what exact model and brand you carry

BALL CHANGE DRUM WASHING MACHINE

The Thermistor temperature sensor works in conjunction with the main control board to monitor the water temperature, the control board could also be faulty if you have already replaced the thermistor.

Unless you are a skilled DIY person, I do not recommend that you try to replace this tub bearing on the washer yourself. One has to virtually strip the entire machine to remove the tub to accomplish this bearing replacement. If you are skilled, then please supply the model number of your machine.

LG Front Load Washer Understanding Error Codes Water Inlet Valve part 5220FR2008F LG Washer Repair

Remove the countersunk screws from the door inner panel to access the handle assembly. The manufacturers part number: LG (OEM) Part #MEB61281101

Check if the counter balance weight is still attached. Sounds like a balance problem. Bruno

the filter is just before the pump on the drain line. it is inbetween the drum and pump. just remove it and replace with new one. go to appliancerepairpros.com and they have viedo

More than likely it went out on the thermal protection devise in the washer, most automatically reset after the motor cools down. Some are mounted at the rear of the washer.