Crosman (4032) - Answered Questions & Fixed issues

I would send it of to fix, playing with compressed gas is dangerous, sound like a seal my have corroded.

Do u still have the gun I've got 1 if u still need information

notify crossman

from a gun shop

The crosman 1008 does indeed fire pellets! NOT BBs. ONLY pellets.

need bolt for crosman silhouette sport pistol looks like a crosman 2300T are they the same? if so where can buy bolt

HI, I found something on amazon. here: Crossman Air Guns Model 760 Pumpmaster Owner Manual English spanish... . I hope I have helped. cheers

Take a look on amazon Amazon com Crosman Powermaster 760 pump and take a look for replacement. have a nice day

check the link..hope it helps

Unless it has a shut off valve, u can not replace it without loosing co2

sounds illegal to me

I have the same problem and have dealt with guns for 40 years !I am glad to see that the other folks have some realistic and innovative ideas of how to remedy this problem.I went to Lowe\'s on a "tip" and found some very small \'O\' Rings for $ 0.87 for two and I am experimenting with them. The first try I couldn\'t crank the screw down far enough to even puncture the CO2 Cartidge. Using a larger screwdriver I finally managed to puncture the cartidge, unfortunately it still leaked but waas a much smaller leak. Still experimenting. I am going on-line to locate the Model 380 Schematic diagram which is where I ran int this site. Good luck all !

Sounds like it has a bad o-ring. you can take it apart and replace the o ring for under a dollar. just make sure you look at how it goes back together when you take it apart they are very simple. just make sure the carefully take the right side cover off with the left side of the rifle laying on a table, everything should stay assembled this way so you can look at it. the part you are looking for is in the large chamber that the pump goes into. from the back (the side opposite the pump) remove the spring and the metal piece behind it, then use something the shove the big brass part out of the chamber and the o ring is on the big brass part . take the old o ring to a hardware store to get another one.

where can we order the spring for this gub?

Ya your better spending the extra money on something with quality

Contact Alan at ABairgun.

I own a Crosman 140 (c. 1962). The nut should be tight.

Richard - in Virginia

Take a short strip of teflon tape and put it over the end of the co2 cartridge, make sure its in straight and tighten, works good.....:)

Yes a new 0'Ring. And maybe a new seal kit. If it is a old pistol then check for other leaks.Hope this helps you out .Also I have a hand full of service repair companys. Joseph

if this is the air rifle i would estimate between $50 used.

try tighnening the screw or bolt that holds the pump on the gun