20 Most Recent Toshiba e-Studio163 Copier - Page 8 Questions & Answers

Toner smart chips are reprogrammable in most cases but you have to have pretty sofisticated equipment to do it. It would not be worth nvesting in such equipment to do just your own cartridges. That being said I am also sure that the estudio 163 does not use a smart chip. It uses just a black plastic box that holds only toner.
Good Luck and Thank You for using Fixya

Can only do if you have a document feeder. Put in originals and pick the offset mode for x amount.

Installation Procedure:
01.Open the machine and take out all tape
02. Open the front cover and right hand side cover + blue lock press and open the black part
03. front side two scrow (big) open
04. Out of PC Unit ( drum and developer Unit)
05. done you Two part the ( drum and developer Unit)
06. developer keep on developer
07. total Items set on the machine
08. main switch on


SP mode
01. 0+5 press and main twitch same time for AJ MODE

02. 0+5 press and main twitch same time for ADMODE

C56 indicates Communications error between the PFC and the CPU on the main PWA. What u can do:
1.Check if the connector CN36 or CN35 on the relay PWA is disconnected.
2.Check if any conductor pattern (PFRXD, PFREQ, PFACK, MACK/PF, PFTXD, or MREQ/PF
between the IC, IC2 and CN36) on the relay PWA is open- or short-circuited.
3.Replace the relay PWA.
4.Replace the PFC PWA.
5.Replace the main PWA.

How u connect your MFP, via USB or network?
If USB, viewer 2 is not supported on window 7 & 2008. If networking, u can try the minidriver.

put in a a4 size sheet an set it up like that

CC9 indicates Upper stack tray lift motor is abnormal on finisher MJ-1011. U need to check the wiring and sensors.

You are trying to print to paper size that is not installed in the machine. Check what paper is installed in the machine then set your software application default paper size to the same value and then print away!

Make sure u download and install the latest viewer2.0.
http://www.copiers.toshiba.com/support/index.jsp

If u cleared the status, and it happen again, then u need to check following:
1. thermostat
2. thermistor

u have installed a toner that is not original ,,,try to put an original toner ,,,and then try or let this toner get empty and then try the original one,,,,

printer require cleaning

make sure its drivers are installed on your computer then follow instructions on your manual on how to scan

Power off machine.....hold "0" and "8" while powering back on. Continue holding until display changes to service mode.

Did u mean that when printing, " no casette with paper" error pop up?
Then u need to make sure u configure the correct cassette paper size on your printer driver.

One of the cassettes is usually universal, if they tray has moving edge guides, the put in the paper you need and adjust the guides.
If the paper needed is in the cassette and you still get the message then the document feeder sensors are miss reading your original size, thy cleaning out the document feeder with a vacuum or compressed air, especially around the paper sensors..

Hope this is of some help
Ed

hi,clean optics,cleaning blade,corotron wires & expousre lamp.

hi dear,

pls search its driver at DRIVERGUIDE.COM

GudLuk

U need to install the usb driver before proceeding to install printing driver for USB connection.