20 Most Recent Whirlpool ED2FHEXN Side by Side Refrigerator - Page 3 Questions & Answers

If it has optics in the freezer, that is the shut off. Is dosent have a wire bail

water valve

The problem is in the control board. A diode is shorting the relay, also has burned off trace. Looking for diode to replace as I write this.

No, you can't. The line goes into the mold of the machine with no access there.You have either an air leak in the dispenser area, around the ice shoot possibly, or the resevoir, which is located on the refrigerator side in the lower area behind the drawers is freezing, which is most likely the case. There are vents on the lower section for the crisper drawers. If you take out the drawers you'll find a roll of 1/4 " tubing which they call a resevoir that cools the water down. This is probably frozen,and you can insulate this, but I would raise the temperature in the fridge side or close the vents to the crisper area. If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

The auger motor is not very powerful, so if you have ice build up in the bin, it can hold the auger motor immobile. Suggest you take the ice bin out and completely defrost and dry before putting back in.

Push button? It should be a turn to the left to remove if it is a whirpool located at the bottom. These are twist out not push to release. The only push to releases are made by electrolux.

NOTE: This
is a multi-solution answer since I don't have all the tech from your question to pinpoint your problem
But the solution is in here generically, if you read and study the solutions very,very carefully.
Check Temp inside freezer. It has to be down to about 10 or 15 degrees
This can cause slow ice making if its too high even tho its freezing everything else at 25 degrees
The ref. temp should be about 33-35
The Freezer temp should be 0 to 10 Any thing below these temps is overkill and a waste of elect
The higher the number you turn it up to is the coldest
The icemaker is 110v
See if water is in icemaker.
Pour water in Ice Maker and wait to see if it ejects.
If it ejects thenyou need to replace water valve in rear bottom of fridge(Its the part that
attaches to water line out of wall)
If it doesn't eject then it is a faulty Ice Maker.
If its leaking or no water at icemaker or door either one, then the valve at the rear bottom of ref needs replacing
First I would check the fan in the freezer. Listen to see if it is running
It moves air to the ref from the freezer
Then check to see if freezer control is turned WARMER, which makes the Ref. colder
Also if it is getting drinking water to the door but not to the icemaker (or vice versa) Then you need to replace
the water valve at the bottom rear of the fridge. It is a double valve and one side is not working
Also this might be a common Defrost problem, Ice
is not being melted by the defrost system.The fan can't blow through the coils into the fridge.
Take out back panel of freezer to check for ice buildup. The coils should be clean.
There are three components to a defrost system- a heater,heater thermostat, and a timer unless you have a defrost electronic card.
Its best handled by a Technician but you could possibly do it by taking your model number to the nearest appliance parts store and asking for the parts. They are mostly located in freezer ,behind back panel on freezer coils.except the card which is usually located in ref The parts store will have info
Also check fan undernearh Ref in the rear
Clean condenser coils underneath
If you still have trouble GO HERE:

http://www.applianceaid.com/procedures.html

I'm including my article on Refrigerator Repair for your help and convenience.;
Please click or copy and paste into browser for Article
http://www.fixya.com/support/r5816737-fix_refrigerator_psychologically
Thanks for using fixya
Leo Ponder
imufo2
PLEASE GIVE A TESTIMONIAL AND VOTE FOUR THUMBS UP IF THIS WAS HELPFUL

Hi,
You will need to replace the electronic control located to the left of the compressor in the back. This board controls the light circuit and I have seen this issue tracing back to the board. The longer you delay in replacing this board, will start to have other issues like dispenser problems and total shut down could be next. I don't mean to scare you but this has happened in the past, all caused but the same failure in the control board. I would need a complete model number with revision number to get the correct part number for you..

Looking forward to help you. I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

First I would check cold control. Thats where you turn it off, if your temp is not warm. it can
be defective and not shutting off. If your temp is warm proceed with the following.
I would check the fan in the freezer. Listen to see if it is running
It moves air to the ref from the freezer
Then check to see if freezer control is turned WARMER, which makes the Ref. colder
Also this might be a common Defrost problem, Ice
is not being melted by the defrost system.The fan can't blow through the coils into the fridge.
Take out back panel of freezer to check for ice buildup. The coils should be clean.
There are three components to a defrost system- a heater,heater thermostat, and a timer unless you have a defrost electronic card.
Its best handled by a Technician but you could possibly do it by taking your model number to the nearest appliance parts store and asking for the parts. They are mostly located in freezer ,behind back panel on freezer coils.except the card which is usually located in ref The parts store will have info
Also check fan undernearh Ref in the rear
Clean condenser coils underneath
Check cold control (thats where you turn it colder)
.I'm including my article on Refrigerator Repair for your help and convenience.;
Please click or copy and paste into browser for Article
http://www.fixya.com/support/r5816737-fix_refrigerator_psychologically
Thanks for using fixya
Leo Ponder
imufo2
Please VOTE FOR ME If this was helpful

Hi they turn very hard , remember lefty lousey and righty titie , and you dont need to turn the water off it will only drip a few drops

Hi,

Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing thencheck out the last two tips.

If your refrigerator is running but warm, then...

Check out these tips that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay
Refrigerator or Freezer not Cooling or Getting Cold

heatman101

Hi Nuabob,
First make sure that the power cord is removed from the supply.

The problem seems to be with the evaporator fan motor , please check if it works properly ,

The evaporator fan is located at the back of the freezer.

You will probably require to remove obstructions like contents of the freezer ,freezer shelves, ice maker and the also rear inside panel of the freezer in order to access the fan.

If this fan does not work then you need to replace it to solve the problem.

If the fan motor is working properly then the problem could be that the door seal is not sealing good , and not allowing the warm air to come into the freezer .

The evaporator motor part number for your fridge is AP3892525 ,

You can buy this part on this link ;- http://bit.ly/mrg8IG

Let me know in case you have any queries.

Hope this helps.

Hi,
Here is a tip that I wrote about the reasons why the sides and/or seals couldbe getting hot on your refrigerator.

RefrigeratorTrouble The Outside of Refrigerator Hot
heatman101

Refrigerators do not emit foul smells.
You have something in the refrigerator that should be removed.