20 Most Recent
Bosch Nexxt 500 WFMC3301 Front Load Washer - Page 5 Questions & Answers
TURN OFF ALARM
Assuming you have allready checked the operators manual, check again on page 19 for "Accoustic Signal".
To deactivate the signal
select a program
press two of the option buttons and hold until a short signal is emitted.
There you have it.
Bosch washer noisy
It is so common that the washing machine can make
terrible noise in many ways and is a common fault. In all occasions it is
important that your observation is most important and so is vital to the
identification /rectification and solution. If you have noticed that machine is
vibrating when it is running then the motor /drum suspension has to be
inspected. Since these fittings are located on the underside of the machine it
is important that you look for the noise with a good inspection lamp. Manually
turn the motor and drum and listen for the noise, if so the motor bearings, the
drum agitator shaft and fittings must be checked. Also the suspensions which
include the shock absorbers and springs, the body clamps must be checked to be
in correct alignment and not changed in position. Tightening of the
mounting is also very important. Finally
in most cases a drop of OIL or smear of grease on the moving parts cane solve
most issues.
Check this link :
http://www.espares.co.uk/advice/washing-machines/a/7/1210/wobbly-washing-machine-or-tumble-dryer.html
For
replacement of bearings check for tips on this visual link: http://www.espares.co.uk/advice/washing-machines/a/7/1401/how-to-replace-the-bearings-on-a-washing-mach.html
What does the E04 error code mean?
E04 means that you are not draining quick enough, if you are using HE detergant then your drain line is probably clogged. There is a round access panel on the lower right corner of your washer. If you stick a small screwdriver through the tiny little hole on this panel and twist the panel off you will see the drain pump catch. You can twist this cap off by hand and remove all the debris inside. WATCH OUT a lot of water will be coming through.
Error E04 on bosch nexxt wfmc32000c
Bosch E04 Solution:
- Get some towels and if possible a wet/dry vac. If the machine drained, it won't be too bad. If your machine is stuck full of water, I can't say! I'd guess you could get wet.
- Locate the round door on the front of the machine (about 6" in diameter, lower right corner)
- Find a drill bit or small screwdriver that fits in the hole in the round door.
- Insert the bit into the hole in the door. It will push in a tab, it doesn't take much force. Rotate the hole (clockwise) to 6'oclock and it should come free.
- Once the door out of the way you'll be greeted by a 3-4" plastic cap with wings so you can unscrew it by hands. There is a small collector lip at the bottom of the cap, that is where I held my wet/dry vac to catch the water. Unscrew slowly so you don't get flooded. Take your time and keep unscrewing it until it is free.
- Pull out the trap that you just unscrewed and you'll most likely see the item that caused the E04 error code. I found one of my two year old's socks. There is an side of the trap that is marked that it needs to be installed facing downward, so watch for that when you put it back in.
- Read these directiosn upside down and backwards to put it all back together.
- Run a load and watch for leaks. You could leave the door off until you are sure you screwed the cap in tight enough.
My washer smells musty
The simple solution would be to fill it like you would to do laundry. Then add a few cups of bleach and run it through it's cycle.
Not finding what you are looking for?