Top 20
Keurig B100 Coffee Maker Questions & Answers
PIt was plugged into a power strip w/a microwave.
The Keurig has had an electrical failure inside, when it failed it tripped your power strip. Once the electrical fault in the Keurig has been fixed you will again be able to run both appliances from the power strip.
Turn it on, won't do a thing, just stopped. Lights up, thats all.
Hi Carol - Sometimes, a product just reaches the end of its life. A product that sees daily (or more use) for 7 years is a pretty good run. Assuming you have cleaned and maintained it, there little more that the end user can do. These makers are more complex that the old "Mr. Coffee" or percolator that used to adorn everyone's countertop; and will often cost more to repair than it's worth. You will find it is easier and quicker to replace it with a new one and probably makes more sense than investing good money in a 7 year old coffee maker.
How do i remove casing of keurig k10
Some of the case is held with compression fittings, which you really have to be careful not to break. A long and very thin flat head screwdriver and some patience can probably get you there.
Keurig blue light flashes display shows prime
Lift the reservoir, then reseat it. This will clear the prime message. If it repeatedly comes back then your machine is dead. If in the year warranty, call Keurig they will ship you a replacement. A common Keurig problem.
Why does the water not desperse?
Try digging out the puncturing needle on the top of the cup mechanism with a safety pin. Often, the pin gets build up from sugars & starches from non-coffee cups. If that doesn't work, try running a tank of pure white vinegar through your machine. That will dissolve any build up from hard water or lime scale.
Water spits in tank but all inlets are open
It may be time to descale. Most models will give you a message when it's time to have the mineral deposits cleaned.
HERES HOW TO DO THAT...
Empty water resevoir. Disable auto off. Pour approx 48 oz of undiluted white vinegar into resevoir. PLace large mug on drip plate, run brew cycle, dump contents of mug in sink. DO NOT USE A K-CUP.
Repeat this process until the add water light is indicated.
Let brewer stand for at least 4 hours while still on.
Discard any residual vinegar in the resevoir and rinse thorughly.
AFTER approx 4 hours...fill resevoir with water.
RINSE:
PLace a large mug on the drip plate and water brew cycle. Pour the contents of the mug into the sink.
REPEAT this brew process until the add water light is indicated.
YOU MAY NEED TO REPEAT THIS "RINSE" PROCESS if you notice any residual taste.
B40wont work properly
I have 2 Keurig coffee makers and have found that if you make sure the seal connecting to the water source and the bottom are tight and the lid is pushed down with the coffee in it, tight it reboots itself. Blinking lights should stop. Also I have found that if the filter needs cleaning sometimes that stops it. Keurig is really great at troubleshooting and replacing their struff call the 1800 # if you don't get results.
Not finding what you are looking for?