20 Most Recent Whirlpool LHW0050PQ Front Load Washer - Page 2 Questions & Answers

I don't think it's spinning all night. If it doesn't drain or the water level switch is telling it otherwise. So you said you cleaned the pump trap ? Right? So next, is it draining the water ? If no the pump is possibly broken. If yes possible clogged black ribbed sump. If all they works and no issues. Check the pressure switch. Let's continue after you tried those first.

Whether it can or not white vinegar should clean it pretty from a spray bottle

When you open the detergent drawer, there are three troughs in the drawer. The trough on the left is for pre-wash, the trough in the middle is for detergent, and the trough on the right is for softner. This is described on page 11 of the users manual. http://c.searspartsdirect.com/mmh/lis_pdf/OWNM/L0412429.pdf#navpanes=0&statusbar=1&toolbar=1&view=Fit&view=FitH Hope this is helpful!

https://www.youtube.com/watch?v=KA5WK7LB-MM

Usually not but if you get a thin blade screw driver, in the center of the baffle gently pry up the edge and wedge it under creating a gap to get the coins out. But be carefully because most of the times you can't get replacement baffles !!

turn your dailer to spin cycle

The control board will need to be replaced. It is located on the top, right hand side of the unit as you look at it from the front. Remove the screws on the top panel, slide it back to remove it. You will see the board. Here is the board to order.

Check to see if it has a Drip Dry or permanent press setting. take it off this setting.

According to the service manual, if the washer won't drain or spin the drain may be clogged. http://www.searspartsdirect.com/partsdirect/user-manuals/27552/lhw0050pq4-whirlpool-parts-residential+washer-manual

usual problem when drum doesnt turn is the brushes on the motor