20 Most Recent Whirlpool AWM8143 Front Load Washer Questions & Answers

The drain pump runs constantly in an effort to drain the water. Unplug the washer and, if the washer is overfilled, check the water inlet valve assembly for proper shut-off of water flow. If the water inlet valve assembly is defective, replace it. If the washer is empty when this error code appears, replace the water-level pressure switch.

F09 is "overflow failure" - check drain pump, pressure switch, blocked drain.
FA is the emergency shutoff switch that detects when water is pooling underneath the machine.

Hello, the F09 code simple means an electronic communication problem with the washer..
To remove the error display, press pause/cancel twice, if pause/cancel does not work
1. Unplug washer or disconnect power for 1 minutes.
2. Plug in washer or reconnect power.
3. Re-select the cycle and press start.

If the error on the display, please call for service

Thanks..



Thanks

try cleaning the area by blowing a can of pressurized air in and around where it latches; or else maybe a bad sensor

Your door latch switch assembly is faulty and needs replacing If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

Hi

Is definatly FA?