20 Most Recent
Whirlpool LSR8433K Top Load Washer - Page 6 Questions & Answers
Whirlpool thin twin washer fills up water but would not start .
We had this happen to our Kenmore washer. Your solution might be the same as ours.
The reason that the agitation cycle won't start is that the safety switch that senses door closure is out of adjustment or broken. They're hard to get at on our Kenmore, so I just took a short length of fish tank plastic air supply hose and slid it over the probe on the door that pushes the switch open. The added length (try half an inch), was enough to push the safety switch and start the agitation cycle. It's not elegant, but has been a permanent solution for us!
1/21/2023 2:49:06 AM •
Whirlpool...
•
Answered
on Jan 21, 2023
Whirlpool top load washer - grease under washplate
If you're finding grease under the washplate of your Whirlpool top load washer, it's likely that the transmission is leaking. The transmission is responsible for turning the drum during the wash cycle, and if it is leaking, it can cause grease to build up under the washplate. Here are a few steps you can take:
- Check the transmission oil level: The first step is to check the oil level in the transmission. If the oil level is low, it could indicate a leak.
- Check for leaks: Look for any visible leaks coming from the transmission. If there are leaks, it's best to take it to a qualified repair technician.
- Clean the washplate and drum: Clean the washplate and drum with warm soapy water and a soft cloth. Be sure to remove any debris or buildup that may have accumulated.
- Check the transmission oil seal: the oil seal may be the cause of the leak, if it's damaged or worn out, it will need to be replaced by a professional technician.
It's important to keep in mind that the transmission is a complex component, and if you're not comfortable working with it, it's best to consult a professional technician for further diagnosis and repair.
It's also important to note that some of these steps require a certain level of mechanical knowledge and experience. If you're not comfortable with checking these items, it's best to consult a professional repair technician if i was able to help my cashapp $ralphpapi thank you have a blessing day
1/15/2023 9:51:16 PM •
Whirlpool...
•
Answered
on Jan 15, 2023
Model #GHW9100LW2. Control lock
Hello & Welcome to FixYa
This is a common issue with Whirlpool Duet washer
however, your whirlpool duet washer needs a reset to resolve the control lock
problem. Press and hold the END OF CYCLE /CYCLE SIGNAL button for 15 seconds to
reset the control. Please get back to me if you have any other questions.
Kevin
1/1/2023 12:35:40 AM •
Whirlpool...
•
Answered
on Jan 01, 2023
Chain Lost in a top load washing machine??
You need to Unscrew the washer pump and search closely inside it, you can watch the following video to find out how to do it by yourself, thank you ??
https://youtu.be/oYL4QqK9LdQ
12/11/2022 10:02:47 PM •
Whirlpool...
•
Answered
on Dec 11, 2022
Only hot water filling washer on all settings
have you replaced the hoses? it's a good idea to do that every few years anyway (they get old and often burst) ... some hoses have an inline screen filter that can get stopped up thus your washer would only get hot water if the cold water hose was stopped up.
12/9/2022 12:27:57 PM •
Whirlpool...
•
Answered
on Dec 09, 2022
Not finding what you are looking for?