20 Most Recent Whirlpool AWM8163 Front Load Washer - Page 3 Questions & Answers


Found it for myself - F7=motor fault. New motor brushes fixed it. This error code will come up if the motor fails to turn on demand at any point in a program, be it filling, in a wash cycle, or spinning.



Hope That Helped;
Thanks For Using
FixYa.com
George
Please Rate Me

Whirlpool... | Answered on May 23, 2009


Remove the bottom casing covering the front of the machine just above the floor. Unscrew the circular cap SLOWLY- beware of vast amounts of water escaping though!
I had to use a low height roasting pan to catch water, and just unscrew the cap enough so as to control the flow of water, and enable to empty water away until its all gone. Incidentally, an old hairgrip was found to be the cause of my problem.
Confusingly, "clean pump" meant clean filter!

Whirlpool... | Answered on May 20, 2009


That means that you need to have the door latch replaced, a bad door sensor is preventing the washer from spinning.
Try first unjamming the latch with a stick, like a pencil for example.
If that does not work, replace the door latch.

Whirlpool... | Answered on Mar 30, 2009


hi there,

Most noises from a washing machine occur during the spin cycle. If you hear loud thumping/or sound
during the spin, the load of clothes may have become unbalanced. Stop the washer and
redistribute the clothes, then re-start it. Repeat these steps if necessary.

Whirlpool... | Answered on Feb 03, 2009


This erroe code means drive motor tackometer error Probably a bad motor or motor drive pc board or cable problems

Whirlpool... | Answered on Jul 16, 2008


its very long diffecult job to do that but i have had luck going to the bottom of tub removeing the drain hose from tub to pump work things out throw the 3 in hole in the bottom

Whirlpool... | Answered on Apr 03, 2008


Electrical module fault
The “Spin Speed” indicator and the “Start
Delay”
option are flashing and an audible tone
sounds. The display shows “F4” to “F16”.
Switch off the appliance. Select a programme
and press the “Start/Pause” button once
again.
The programme will continue.
If the fault re-occurs, contact After Sales
Service (see “After-Sales Service”).

the user man can be found here
http://www.whirlpool.co.uk/app.cnt/whr/en_GB/pageid/pgsrvifuhome001

Whirlpool... | Answered on Mar 03, 2008


be best to have repair man that done it it can be a long job and not finished 4 someone that never done it

Whirlpool... | Answered on Mar 03, 2008


There are a number of possibilities here;

you are in a hard water area and that is deposited calcium. Use Calgon or some type of water softener.

You are using washing powder instead of HE (high efficiency) liquid.

You are using a cold wash with powder when you need to use warm water.

The washing machine needs descaling. The white is calcium from the heater element and tank.

Whirlpool... | Answered on Jan 11, 2020


There should be an open end at the back of the washer, where the house initially was fixed.

Whirlpool... | Answered on Jan 09, 2020


If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the F05 error code will be displayed. Might need to be taken to a repairman

Whirlpool... | Answered on Jan 07, 2020


Resolution: Error code F11 = Serial Communication Error. Error codes can be caused by a Power Surge or other electrical anomaly,attempt to return the washer to operation by following the Hard Reset procedure below. In some cases the control can be non-functioning or may not accept activation from the control panel.Aug 25, 2009

What does error code F11 mean on a Whirlpool Duet washer, model ...


https://www.shopyourway.com > questions

Video

https://www.youtube.com/watch?v=6tEpImEIOBo

Whirlpool... | Answered on Jan 06, 2020

Not finding what you are looking for?
Whirlpool AWM8163 Front Load Washer Logo

55 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Whirlpool Washing Machines

  • Whirlpool Washing Machines

Most Popular Question

f h displaying

  • Washing Machines
Loading...