20 Most Recent Whirlpool AWM5104/1 Front Load Washer - Page 7 Questions & Answers

LSQ9549L

How do I fix error code f02 on Whirlpool?"); display: inline-block; height: 24px; width: 24px; transform: rotateZ(-180deg);"> Make sure the drain hose is not kinked or clogged. Straighten the hose for adequate water flow. Remove any blockage from the drain hose, drainpipe or utility sink. Use the U-shaped drain hose form on the drain hose, and secure the drain hose.

Turn off the water. Remove the inlet hose and clean the gauze strainer, replace and try again. If it still does it, it may be the water inlet valve needs replacing.

Clicking is fair enough as older machines which dials have a rotary motor driven switch, and also when water inlet valves open and close. Popping though is not so good and often happens when water meets electricity.

copy and paste https://www.partselect.com/Models/WTW5840BW0/

make sure drain hose is above drum

possible weak water solenoid

if belt on drum ok check under agitator for worn cogs

Question edited for full 'make model (what it is). Question moved from Refrigerators to Washing Machines. They tend to stick because of rubber on plastic adhesion. Rock up and down. https://www.google.com/search?q=whirlpool+wf810w+remove+filter ..

That is an easy one to fix :>D If uL (unbalanced load) appears in display, the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.

uL - Error Code - Washer - Product Help - Whirlpool Canada

Hi, please reset the washer by unplugging it's power for 1 to 2 minutes before plugging the power back in and pressing start. If the issue reoccurs, please switch power outlets and try again. If all else fails, please review the troubleshooting section of your manual. Thank you.

Stacking kit in the link https://www.google.com/search?q=whirlpool+washer+type-DALP-ELE-2406024EL54+stacking+kit ..

First unplug the washer. Next grab the seperator on top of agitator pull off then you will see a 7/16 bolt take it out then pull agitator out when reinstalling it back do it in reverse. Good Luck Mike L.

google whirlpool awg 371 parts copy and paste https://ziperone.com/models/3363/59/252253 https://fixpart.ie/en/appliance/view/W06090

Videos https://www.google.com/search?q=replace+door+seal+on+whirlpool+w9151yw00 ..

The error code F7 indicates there is a problem with the motor. It fails to get to the required speed for the wash cycle. Make sure the drum isn't too full. Also make sure all transit bolts are removed.

use a meter to diagnosis what has failed --breaker - circuit - motor - etc

Could be a defective cycle timer or failure of some element controlled by the timer such as the pump.

The drum may need to be replaced for your washing machine and the parts that allow the drum to rotate might also need to be replaced as well.

see if power to control board