LG WM2101HW Front Load Washer, White, 4.0 cu.ft. XL Capacity with NeveRust Stainless Steel Drum IEC, Direct Drive Motor for the Ultimate in Durability and Reliability, 1100 RPM Maximum Spin for EfficientWater Extraction, SenseClean System for Intelligen - Answered Questions & Fixed issues

You say that you replaced the door switch, but you need to check that the spring of the latch hook inside the door is working properly, otherwise it does not hook properly and will cause these problems.

Check the screens on each end of the filler hoses to ensure they are clean and sand or rust free.

bleach? do u mean detergent? normally machines run pump/then start to fill.water will pass through drawer then they heat /wash/drain/spin then refil for rinse conditioner/spin rinse drain fast spin end pretty much

LG WM2101HW 4.0 cu.ft. Washer Stains clothes ruining ...

www.fixya.com > ... > LG > LG WM2101HW 4.0 cu.ft. Washer ... stains out with anything and they are ruining numerous items of clothing. ... stainson light objects ie making white marks on light blue clothes ruining these ... by greasestains from their front loader Kenmore. .... remove the agitator from a ...

Main control board needs replacing.

might door handle was broken because of that its haperning,,

Could you explain the "no start" condition? Does it fill and not agitate?Do you get any lights on the unit? Does it dispaly any error codes?

This dE error or fault code to indicate that the door is not latching properly. Check the lid or door operation to be sure it's not binding and that the door alignment is correct. Also, check the door/lid hinges to be sure they're not binding. Finally, make sure the door catch is in place and not broken. You may need to replace the door hook/catch or the door lock assembly.

its best to get an engineer to the problem as it could be anything at all or just an alignment problem eric

Sounds like the dial timer is defective, I am not affiliated with this site, https://www.repairclinic.com/Video

http://www.lg.com/au/support/support-product/lg-WT-H9556

https://electronicshelponline.blogspot.com/ http://homenol.blogspot.com/ Visit this site to get some details.

Remove the screws that attach the top panel at the back of the machine, slide the top backwards and remove the top panel. Run the machine as per normal, but be careful as the electrics will now be exposed, you will be able to see where the water is leaking from and be able to repair/replace defective part.

If you wish to get some details; check the site linked here. Pull up older posts........ http://electro-medical.blogspot.com/

take the back off see if the water pump making that noise or is broken should look something like this one

2 possible causes the water solenoid control valve is split in the diaphragm and not stopping the water the small hose from the base of the tub to the level control pressure unit is split or disconnected or the pressure unit has failed and is not activating the water control valve

Take out the soap drawer and clean the fabric softner compartment. This happens when there is residues left. And it gets clogged up.

The obvious question is how do you know that it is soap? What washing machine is it? The biggest problem with most washing machines is that people use too much soap to begin with. I would go to a store and get a new t-shirt or something. Run the machine with nothing in it. Then put the shirt in and run it again without adding any soap. When it is done check the shirt for soap. There could be a build up on the inside of the drum.

Please do not do another load of wash until this problem is fixed, or you may find yourself with a house/apartment fire! I am thinking your motor (most likely) or the controls (least) have a short, and are causing your problem. Oh, yes. Take a really good look at the circuit breaker box inside, because a broken or loose ground wire ( there are two) can also cause this problem. One ground wire should be white, one should be bare. Each should be securely screwed into the lugs of the grounded section of the circuit breaker box. God bless your efforts.

pull back the lip and look for a wire and spring that goes around the gasket. check out repair videos on repairclinic.com or appliancepartspros.com.