20 Most Recent
LG WT4801CW Top Load Washers - Page 5 Questions & Answers
Pe code fix on lg washing machine
This means that the water pressure switch did not return the water level in the expected length of time. Unplug the washer for several minutes (up to 10) to check for a transient error. Make sure that the washer drain isn't siphoning out the incoming water. (The end of the drain hose in the stand pipe or sink should be higher than the highest water level in the washer.) Check that the wires haven't come loose at the pressure switch. Check that nothing is blocking the air tube attached to the switch. Check the wiring harness for corrosion or damage. (Check the pins at both the switch and the control board. Make sure that the wiring harness has continuity on all of the conductors.) If the problem goes away after cleaning, then you're good. If the wiring is damaged, replace that. If the problem doesn't go away, then the pressure switch should be replaced.
If the washer won't start the wash cycle before giving the PE error, the heating element could be the problem. Check the resistance across the element.
If the washer shows the PE error when you press start or are setting a wash program, then the either there is damage to the elements that control the pressure switch or control board is damaged and has to be replaced.
If you see random PE errors, check for other loose wiring, particularly between the heater and the control board. Make sure to twist wires together securely and add shrink tubing to insulate the wires.
I hope this helps.
Cindy Wells
Cl code on LG inverter direct drive 9kg washer
The child lock feature has been turned on your washing machine and when the child lock has been activated the control panel will not work and the settings can't be changed either. To turn off the child lock feature press and hold the child lock button for about 3 seconds.
LG 8,2 water overflowing
There is usually a tube next to the drum that has a sensor on it and that tube fills with water. It can get plugged up with softener or debris and then the machine wont be able to tell when it is full. To get to the tube, you must remove the tope of the machine.
Not finding what you are looking for?