20 Most Recent LG WT4801CW Top Load Washers - Page 9 Questions & Answers

possibly the bearing seal is gone , suggest calling a local repair service

Solution. Unplug the machine. Hold the power button for 10 seconds. Plug back in. Push the power button and the washer should turn on. Walk away leaving the machine on. When I did this, I came back to find the drum light off and machine would start on command now. Good luck.

SUSPECT DOOR LOCK IS NOT WORKING

A domestic appliance repair company may be able to source the spares for you and possibly fit it.Spares are not likely though as door inners don't break whilst the machine is under the manufacturers warranty so spares are probably not available.

you need to define where it is leaking from as we cant see it.

Look inside for the missing fasteners/ screws

Look at where it is leaking from, possibly under the drum.

that is strange, either your filters on the hoses are blocked or your water inlet valve is failing. Worst case scenario, it is the control board!

if voltage to unit see if past switch if ok check past control board if ok to motor bad motor

if power to motor then bad transformer if voltage ok bad motor

https://www.republicworld.com/technology-news/gadgets/de-error-in-lg-washing-machine.html

Make sure your water inlet hoses are not revers.

Door is not closed or the door latch has broken/been misaligned

Hi, The OE code signifies that your LG washer is unable to drain the water out during wash cycle. This code can be triggered by a clogged drain pump filter or a drain hose that's kinked, it could be that coins etc have blocked the pump or drain filter assembly, at the bottom right of the machine there is a panel, if you open this and follow the instructions to evacuate the machine of water, then open the cover behind it, and remove the filter assembly and clean it out maybe with an old tooth brush etc. and also the pump area use a damp cloth to remove and grit etc from the thread and replace the cap securely, start the machine a new and watch for any leaks check out this page for full details on this https://howtofixit.net/lg-washing-machine-oe-error-code-explained/ i hope this was helpful.

LG WA 80250NP lights flashing first and second row PLEASE HELP

Probably a leaky pump or related component

Normally indicative of a 'slow fill' issue. Turn off the water. Remove the hose connectors at the rear of the machine and check the strainers for limescale and debris. Have someone hold the hose in a bucket or sink and turn on the water to check flow and pressure. Reconnect, turn water on and check for leaks.

Probable bearing issues.

probably a bad control board hard to say without any testing

it needs the inlet valves replaced