20 Most Recent
Weber Genesis Silver B Grill - Page 4 Questions & Answers
When we light the grill the burners only have a
Hopefully this will fix you up. Follow exactly.
- Turn off the gas at the propane tank
- Disconnect the gas line from the tank
- Open the grill lid
- Turn all control valves to high
- Wait for about a minute
- Turn all control valves to off
- Reconnect the gas line to the tank
- SLOWLY turn on the gas at the tank
- Light the grill normally
- Your grill should now heat normally
My Weber genesis silver is working but the flame
Occasionally you can clear air from the burners by turning the burners on (with gas shut off) and disconnect the propane tank. Once the tank is disconnected, turn the burners off and reconnect the tank. This should dispel any air. You can also take a wire brush and "gently" brush the burners. Occasionally a little debris will clog the burner. Since this seems to be happening on all of your burners, it's a good bet it's air causing the problem.
I need new burners but
Here's one way you can tell. The 'A' doesn't have a side burner and the
'B' does. Other than that, there's little to no difference between the
two.
Hope this helped you and thanks for choosing FixYa.
Very low flame /full tank
Hi dahlhaus2...
Check your burners for plugged up holes, or burn-outs in the flame control element (burner).
Check your regulator, it can sometimes stick and not allow the right amount of gas to the burners.
Check to make sure the hose has no holes in it.
Check your control valves for trash in them restricting the flow of gas.
Sometimes if the regulator is sticking, you can take a hammer and lightly tap on the regulator and it will unstick the valve that controls the gas.
If none of this works, then replace the gas regulator it is faulty.
Please take time to rate me thumbs up
Not finding what you are looking for?