20 Most Recent
Emerson EWL3706 37 in. LCD Television - Page 6 Questions & Answers
Need remote code
There is no code, I had to use the remote from Com Cast. So you have two remotes, one to turn it on and one to do the rest.
Emerson 32 inch flat goes immed to stand by when you turn it on.
this is almost always caused by a bad inverter board, looking at the back of the tv, it is the board all the way on the left, i dont think you can get that board by itself--it comes on the panel, but you can get the transformer chips, those are next to each plug that plugs into that board on the left, usually 5 or 6 of them, you have to unsolder the old ones, and solder the new ones on, tyey are usually the problem, and alot cheeper than the board, they cost about 35 dollars for them all
My Emerson flat screen
If it's like mine, you would have to keep replacing the inverter transformer. It's a junk part that everyone is having a common problem. The repair shop may have replaced the bad one, but that doesn't mean the others will go bad later. I have a 32" that uses 6 inverter transformers.
Cuts off picture at top of screen and bottom of screen
good luck tryin to find a universal remote i cant...but if you do there should be a button that might say something like pip, pix, screen mode something like that and it will make the picture streach to fit the screen however not all channles will be set on the same screen settings.
Won't turn on
the problem is possible into your tv power supply area. could be a burn capacitor or a busted fuse on the area.
it is better to bring your unit to your dealer for the warranty since you buy it only on march 2008.
I have a 37in LCD
sounds like a failed backlight or inverter.
larger LCD sets use multiple lamps horizontally across the screen.
There is a line going across my emerson LCD
this is a chip on film problem and cannot be fixed take it back and have it replaced , they may want to send it to a repair site but they will scrap it and you get a new set.
Zoom problem
there should be a BUTTON ON THE REMOTE SMALL ON TOP RIGHT OF CENTER CROSHAIR IN MIDDLE THAT SAYS SOMETHING LIKE VIEW MODE PRESS IT AND YOU CAN SWITCH BETWEEN ZOOM, STRETCH ECT. ALSO IF YOU HAVE DIGITAL CABLE AT HOME THEN THEY ALSO HAVE A ZOOM BUTTON ON IT AS WELL LOOK AT YOUR REMOTE HARD THESE BUTTONS ARE USUALLY THE SMALLER ONES.
My emerson tv is turning it self off
A very common power supply problem these TVs made by Funai seem to have. You will need the Mfr to repair it for you. Call them at 1-800-242-7158 for assistance.
My TV died this morning
Sounds like a power issue with the unit you will have to call the customer suppport line and have them refer you to an authorized dealer or send it back to them.
Too dark
Check the energy saving setting in the picture menu. It could be all the way on, turning it off makes a big difference.
Connections on back of TV
You can download the manual from the link below:
http://www.emersonaudiovideo.com/pdf/om/EWL3706.pdf
Please update the question & let us know if the information given was useful to you - Good Luck!
How to setup a onn remote control to a emerson TV
1. Turn on your Emerson TV.
2. Consult the ONN remote manual for Emerson TV codes.
3. Press TV on the ONN remote.
4. Enter the correct code.
5. Test remote functions.
- If unsuccessful, try code search or auto-programming.
6. Ensure compatibility.
1/8/2024 3:58:07 PM •
Emerson...
•
Answered
on Jan 08, 2024
Not finding what you are looking for?