20 Most Recent
Gestetner DSm618 All-In-One Printer - Page 8 Questions & Answers
Light copy
check for the quantity of deloper, toner and also claen the optics and the glaaass covering the laser unit .
Error 120 code
To reset the SC code follow these directions:
Resetting Ricoh Savin Lanier Gestetner SC Error Code
Error code 120 is scanner home position sensor problem. If it's a recurring problem, here are some troubleshooting tips:
SOLUTION:
Turn the main switch off and on.
Check the wires between Home Position sensor and the SBU.
Fix scanner board or the SBU .
Check the wires between scanner motor and the scanner I/O board
Fix the scanner motor.
Fix the Home Position sensor.
Fix pulley, timing belt, the scanner wire,
Fix the carriage.
Faint printing
check if you have more developer in the unit or toner and also clean the scaner and laser optics
Savin 8045 sc544
error 544 is associated with the fuser, call aechnician to change the thermisters and thermofuse of the fuser and the problem is solved
goodluck
How to re-set sc 322
322 is a laser problem
remove the laser and wash in a clean water with detergent .\
dry it under the sun for about three hours and refix it back .
if the problem persist ,
call for a change of laser.
good luck
Dsm730 reset usine
1. press the counter key,
2. press and hold the (#) key and tap the system settings on the touch screen. The screen will read (change settings to factory settings)
3. press yes and wait for the reply of completed .
4. put off the machine and restart ity.
GOOD LUCK.
How can i clear the error code sc690 to my afficio Gestertner Dsm 635
sc690 is the error associated with the white flat cable connected to the laser.
First of all , open the front door of the machine and remove the cover to the laser unit .remove the flat cable and and clean the alluminium surface with menthylated spirit carefully and and fix back the cable .cover it and power the machine.
If the error appears again,change the complete cable if you can, but if you cant then call an expert .
GOOD LUCK;
Eonon problems 1306
it is the hard drve error .
just disconnect the hard drive from the board andput on the machine.
bt remember you cannot store files since the hard drive has been disconnected.
good luck
How do i clear SC542
Press the yellow button then type in 107 and hold the red stop button down for more than 3 seconds. On the drum go to modes, no. 5 then you must scroll down till you see clear sc codes press ok and then execute. You must then turn the main power off then on again. If the problem still occurs then you must replace the thermistors, there are 2. Replace them both.
Not finding what you are looking for?