20 Most Recent
Frigidaire FRS3R5EMB Side by Side Refrigerator - Page 6 Questions & Answers
The temp in the box dont reach desired temp
Hello Troy, thank you for your post!
According to the above-listed model number you seem to have a side by side refrigerator, is that correct? If so, often if it is not cooling, it could have floating restriction in the line or something more complicated like an issue with the sealed system that only a professional can repair. This can include the compressor not working, the evaporator fan not turning, or even coolant in the lines at incorrect levels to properly cool. I suggest cleaning the unit out including the coils you can reach (typically located in the bottom behind the toe grille) and make sure no food items are blocking any vents in the unit. Also try checking and see if the door seal is bad; place a dollar bill between the body of the freezer and the door. Now close the door. The dollar bill should stay in place and pull out with a small amount of resistance. If the dollar bill falls out when placed between the gasket and cabinet double check to see if the door is being blocked by anything stopping it from closing. If any of these suggestions prove to be ineffective, connect with a professional to accurately pinpoint any potentially more serious issues.
Refrigerator will not cme on
Good Morning Winona, thank you for allowing me to assist
you!
According from the model number posted above you seem to
have a side by side refrigerator, is that correct? If so, often when a refrigerator
is not cooling, it could have floating restriction in the line or something
more complicated like an issue with the sealed system that only a professional
can repair. This can include the compressor not working, the evaporator fan not
turning, or even coolant in the lines at incorrect levels to properly cool.
As part of routine maintenance, I suggest cleaning the condenser
coils (typically located at the foot of your refrigerator) by unsnapping the
sides and lifting outward towards you. Now, using an extended vacuum attachment
and condenser cleaning brush, remove dust buildup from condenser coils on left
side underneath refrigerator. Cleaning condenser coils typically resolves this
issue.
Make sure no food items are blocking any vents in the unit.
Also try checking and see if the door seal is bad; place a dollar bill between
the body of the freezer and the door. Now close the door. The dollar bill
should stay in place and pull out with a small amount of resistance. If the
dollar bill falls out when placed between the gasket and cabinet double check
to see if the door is being blocked by anything stopping it from closing. If
any of these suggestions prove to be ineffective, connect with a professional
to accurately pinpoint any potentially more serious issues.
Refrigerator FGHX2644KF2, THE FREEZER IS NOT
is it staying at 16?? a freezer thats attached to a refrigerator would be considered fully functional about id say 30 degrees and below, As long as it stays under 32 I wouldnt worry about it, you can always try unplugging it for a few minutes if you want, but as long as temp stays at 16 or lower than 32, its fine............. a deep freezer are the ones that usually get alot colder than 32, but generally only because thats the systems only job, its not also running a refrigerator.
Frigidaire FRS26HF6BW2 side by side Refrigerator,
The plastic feed line from the inlet valve in the bottom right hand side of the back going up to the top left hand side feeds the filter. You can shut-off the water from the house tap, and then cut the plastic filter feed line in the middle somewhere, and install a john-guess coupling on the inlet valve end of the cut line. Then you can tip that line into a bucket, turn on the water tap and see if water comes out into the bucket, if it does, then proceed to the next step. Sometimes the filter cartridge has a thin piece of plastic that remains on the cover, obstructing the water inlet ports in the filter housing. Always use a mfg.'s specified filter, not a Chinese "Knock-Off".
Frigidaire FRS26HF6BW2 side by side Refrigerator
Memory card is not opening and when i connect in pc so they show error like.. there was a problem starting -WKBPBCM.init the specified module could not be found.... so please solve my problem
Fans on inside are not blowing
Good Morning,
thank you for allowing me to assist you!
If the fan of your refrigerator is not running, it is could be in regards to a possible
sealed system issue, faulty temperature thermostat or fan. The fan runs to
maintain temperature and receives power from the temperature thermostat. Do you
hear the compressor running? If you do not, at this point, I would personally
contact a professional to accurately diagnose your refrigerator to determine
the root cause to reduce the risk of unnecessary parts.
10/30/2013 12:25:36 PM •
Frigidaire...
•
Answered
on Oct 30, 2013
Door handle loose
should be little covers that cover screws on the handle top and bottom. use a small flat screwdriver or equivalent to remove covers, then tightenscrews. put covers back on and you are done
Fridge GLHS37EHS135 the ice dispense button will
Hello mij, thank you for your post!
I'm not certain I understand your
inquiry. However, if your ice
maker has stopped producing ice completely, please check these, in this order:
1.
Your
ice maker may be turned off. Look for the wire along the right side of the ice
maker that looks a bit like a coat hanger. If the wire is in the raised
position, the ice maker is turned off. If so, try one of these: If your ice
maker has a small red plastic lever, lower it to lower the wire. If there's no
plastic lever, simply lower the wire. In either case, the ice maker should
begin producing ice again.
2.
Also
make sure that the temperature is 8 degrees Fahrenheit or lower. If the freezer
is too warm, the ice maker won't cycle properly.
3.
The
ice maker fill tube may be blocked with ice. If so, melt the blockage using a
hair dryer - but be careful to not melt any plastic parts!
4.
Also
replace the water shut-off valve or water-inlet valve, or both, if necessary.
The ice maker head assembly may have broken parts. Look to see if the gears are
broken. Check to see if the small plastic arms that rest against the ice rake
are broken. If the ice maker head assembly is modular and you've found broken
parts, you can just replace it
Should
these suggestions prove ineffective, I would recommend contacting an authorized
service technician that will be able to assist you in the diagnosis and repair
of your ice maker. If you do not have a
professional connection, you have the option to visit the manufacturer website
to find a service provider in your area. Or if this is not the issue your
refrigerator is experiencing please feel free to reconnect.
Microwave won't power up when plug in
Good Afternoon Racquel, thank you for allowing me to assist you!Honestly without the unit being accurately
diagnosis they are multiple possibilities. However, since the microwave is no
longer operational, it sounds like either the main control board has blown or
wiring failure. If I was in your position, I would strongly recommend consulting
a certified technician to narrow down the prices issue before investing in
parts that may or may not be the root cause. You can often locate a qualified
service provider through the manufacturer website.
Very little water stream from the water dispenser.
make sure your water feed line is not to long, they come with 1/4" conneting but if to long you lose wter pressure, need to increase tubing to 3/8" tubing also make sure water valve is wide open an water line is not kinked anywhere
Ice crusher not working
Remove the ice tray and check to make sure that it is not froze up with with ice. the bottom of the tray has a rod attached to it that controls a flapper that opens and closes to allow the ice to pass thru without hitting the cutter or closes to hit crush blades. make sure this is not in a bind or froze up. this rod goes into a plastic housing at the back of the freezer that has a solenoid switch that activates it to open it up. check to make sure all of these items are free of ice and in their proper position and or not broken.
My display code says 5Y EF
Good Morning Karen, thank you for allowing me to assist you!
Typically error code SY CE, is commonly referred to an issue
between the main control board and the user interface (the control on the
Freezer door). A tech would typically check the communication wiring wires
between both parts to determine the cause of the error code. If the wiring is
correct, then more than likely you are looking at a faulty main control board
or user interface. Regrettably, this is not a simple DIY job. I would highly
recommend reaching out to an expert technician to ensure the appropriate
replacement part is ordered and is installed correctly to prevent future
issues. I hope this information helps to some degree - thanks for your
question, and please do not hesitate to reconnect.
10/11/2013 12:31:02 PM •
Frigidaire...
•
Answered
on Oct 11, 2013
My refrigerator cut off then back on last nt got
Hello Mike, thank you for allowing me to assist you!
Let's try resetting the refrigerator by either unplugging or
flipping the household circuit breaker. It is important to wait approximately
ten minutes and then turn the unit on. If you do not hear the compressor running,
then the issue may lie with a sealed system issue, such as a faulty compressor,
start relay, or the evaporator fan not turning. If there is absolutely no
power, then your appliance may possibly have a potential wiring failure,
damaged power cord or control board. Typically these are not simple DIY jobs
and these parts are commonly replaced by experienced service technicians. You can often locate a qualified service
provider through the manufacturer website.
Best regards!
Not finding what you are looking for?